779730
27
Zoom out
Zoom in
Previous page
1/30
Next page
27
19. CICLOGUIDE2
You can find the software «CicloGuide2» on our homepage www.ciclosport.com for free download.
Please install the software on your PC. Before you start the «CicloGuide2», the NAVIC 400 has to
be connected with the enclosed USB cable and the PC, as the software directly acquires and then
displays the data of the NAVIC 400 at startup. The software «CicloGuide2» helps you to manage
your device. With the help of the software you can keep the NAVIC 400 always up to date by
updates.
You can also delete maps from your device and «load» other «country maps».
With the software you can also manage your GPX files and decide whether they should be stored
directly in the memory of the device (if there is enough space) or on the optionally available memory
card.
20. TROUBLESHOOTING
Problem
Possible cause
Solution
Navigation device
does not start
Battery capacity too low
Connect the device to a suitable power source. The
unit should then start automatically after a few
minutes. If the device is not used for a longer period,
please switch it off completely. Press the on/off
switch and tap «Switch off».
No GPS reception /
GPS reception is
interrupted
GPS reception may be
disturbed in the forest or by
narrow urban canyons,
heavy cloud cover, etc.
Reposition the navigation device if necessary. At
least 4 satellites are required for navigation.
This information is available on the device under
«Settings» -> «GPS Info».
Device no longer
responds to inputs
Occasionally, overloading
may cause the device to
stop responding
Please reset the unit by pressing the ON/OFF button
on the right side of the unit for about 15 seconds until
the unit starts up again.
Compass does not
align properly
Compass does not
align properly
Compass does not
align properly
The compass should be
calibrated regularly
Calibrate the compass again. Hold the compass
horizontally for the best possible functionality.
The unit is not held leveled
enough
Do not tilt the unit more than 70° horizontally when
using the compass.
There are interference
sources in the immediate
vicinity
Make sure that there are no interference sources
such as magnets or power lines in the vicinity.
Barometer values are
not correct
The barometer should be
calibrated regularly
In case of weather changes or if you have to cope
with large differences in altitude, you should calibrate
the barometer several times a day
The destination you
are looking for cannot
be entered
The destination you
are looking for cannot
be entered
The corresponding country
map may not be available
Please check whether the corresponding detailed
map is included in the scope of delivery or already
pre-installed. For a possibly necessary installation
please use the CicloGuide2 software.
Town / street / house
number are not included in
the map material
Select an adjacent city / street / house number in the
input mask. Alternatively, the destination can be set
manually in the «Map» view.
Despite the latest map versions, there are still
unrecorded areas.
Elevation jumps are
included in the track
The barometer was not
calibrated before starting
theTrack recording.
It is recommended to calibrate the barometer
manually, by entering an altitude, especially before a
track recording
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ciclo Navic 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ciclo Navic 400 in the language / languages: English as an attachment in your email.

The manual is 1.27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ciclo Navic 400

Ciclo Navic 400 User Manual - German - 31 pages

Ciclo Navic 400 User Manual - French - 32 pages

Ciclo Navic 400 User Manual - Italian - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info