585818

Christopeit SP 20 XL Fitness Station Manual

20
Zoom out
Zoom in
Previous page
1/48
Next page
20
Assembly Instructions
Before beginning assembly, be sure to observe our recommen-
dations and safety instructions. Take out all parts from cartons
and lay down on the floor. Some parts are pre-assembled.
Step 1:
Installation of base frame (17), rear foot (18) and main frame (34).
1. Place the rear foot (18) at base frame (17) in the right way on en
even floor together so that the holes align and screw them with hex
bolt 10x65 (49), flat washer 10//20 (67) and nylon nut M10 (64) tightly.
2. Place the main frame (34) onto the base frame (17) and screw it
first vertically with carriage bolt M10x65 (53), curved washer 10//25
(71) and nylon nut M10 (64) tightly. Then tighten the main frame (34)
horizontally to the base frame (17) with hex bolt M10x70 (48), flat
washer10//20 (67) and nylon nut M10 (64).
3. Place the backrest (13) at the main frame (34) and screw tightly
by using hex bolt M8x65 (54) and curved washer 8//25 (72).
4. Cover all screw heads of screws (48+49+54) and nuts (64) with
corresponding screw caps (74+75).
Step 2:
Installation of sliding tubes (5) and weights (31+32).
1. Insert the sliding tubes (5) into the holes of rear foot (18) and fix
them with hex bolt M8x60 (55), washer 8//16 (68) and nylon nut M8
(65). Then cover all screw heads of screws (55) and nuts (65) with
screw caps (75+76).
2. Slide the bottom cover bracket (22), 2 rubber bumper (10), the
weight supports (83) and again 2 rubber bumper (10) onto the sliding
tubes (5). (Note: If you bought the option weight set Art.-No. 9389
you put on the 2 additional weight plates (32) instead of the weight
supports (83)(Fig. 1). Then slide all weight plates (32) by viewing right
direction onto the sliding tubes (5) as shows in fig. 1 or 2.
3. Slide the plastic ring (35) onto the pull rod (36) and secure with
limit bolt (37) in uppermost hole. Insert the pull rod (36) into the
weights (32).
4. Slide the first weight plate (31) onto the sliding tubes (5) and put
the plastic washer 13//40 (1) on top.
5. Put the 2 adjustment screws (33) into the appropriate holes of
top cover bracket (82) as figure 2 shows and fix them with washers
8//16 (68) and nylon nuts M8 (65).
6. Slide the top cover bracket (82) onto the sliding tubes (5) and
insert the security pin (30). To adjust the weights, use the security
pin (30) and put it into desired position of the pull rod (36).
In this case, the higher the locking pin (30) is inserted, the lower
the weight load.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Christopeit SP 20 XL Fitness Station at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Christopeit SP 20 XL Fitness Station in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info