793036

Christopeit EL 5 Manual

21
Zoom out
Zoom in
Previous page
1/68
Next page
21
English
Installation instructions
Remove all the separate parts from the packaging, lay them on the floor
and check that all are there on the basis of the assembling steps. Please
note that a number of parts have been connected directly to the main
frame and preassembled. In addition, there are several other individual
parts that have been attached to separate units. This will make it easier
and quicker for you to assemble the equipment. Assembly time ap-
prox. 50min.
Step 1:
Attach the stabilizer (2+3) at main frame (1).
1. Attach the front foot (2) with the preassembled transport rollers (4) to
the main frame (1). Do this with the two carriage bolts M8x75 (6), curved
washers 8//19 (7), spring washers for M8 (8) and cap nuts M8 (9).
Attention: Mount the front foot into right
direction, so that the transport rollers don’t
touch the floor during exercising. The arrow
show top side.
2. Attach the rear foot (3) to the main frame (1).
Do this with the two screws (6), washers (7),
spring washers (8) and cap nuts (9).
After assembly has been complete, you can
compensate for minor irregularities in the
floor by turning the end cap (5). The equip-
ment should be set up that the equipment
does not move of its own accord during a
training session.
Step 2:
Assembling of the connection cable (55) to the motor cable (12) and
installation of support (49) at the main frame (1).
1. Place 8 screws M8x16 (39) with curved washers 8//19 (7) and spring
washers for M8 (8) accessibly beside the front part of the main frame (1).
2. Place the lower end of the support (49) against the main frame (1) and
slide first the handlebar tube cover (57) onto the support (49). Plug the
ends of the two computer cables (12+55) projecting from (1+49) together.
(Note: The connection cable (55) projecting from the support (49) must
not slide into the tube, as it is required for later steps of installation.) When
joining the tubes, ensure that the cable connection will not trapped.
3. Put one spring washer (8) and one curved washer (7) on each screw (39).
Push the screws (39) through the holes in the support (1), screw into
the threaded holes of the main frame (1) and tighten lightly. (This screw
connection point will screw firmly at least in Step 3.)
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Christopeit EL 5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Christopeit EL 5 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4.32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info