602837

Christopeit BLUE T2 Manual

19
Zoom out
Zoom in
Previous page
1/60
Next page
19
English
Step 4:
Installation of the pedal tubes (28) at swing tubes (38) and hand grips (41)
and connection at pedal cranks (12).
1. Push the end of the right pedal tube (28R) onto the right pedal crank
(12R) and tighten it with screw (24), washer (23) and spring washer (14)
firmly.
2. Push one save cover (40) onto the right swing tubes (38R). Push the
swing tube (38R) into the right handgrip (41R) and tighten it with screws
(13), spring washers (14) and washers (39) firmly.
3. Install the left pedal tube (28L) with all additionally required parts on the
left hand side of the machine as described in 1. - 2.
Step 5:
Installation of the front/rear pedal tube covers (25+35) and pedals (31)
on pedal tubes (28).
1. Push the rear pedal tube covers (25) onto the rear end of pedal tubes
(28) and fasten it with screws (26).
2. Put each one of left and right pedal front cover (35L+35R) onto the front
end of pedal tubes (28) together and fasten them with screws (11+26).
3. Place the footrest (31) onto the pedal tubes (28) so that the bores of
pedals (31) are aligned with one of the possible installation positions at
pedal tubes (28). (Note. The high edge on the long side of the footrest
must point inwards (towards the main frame (1).)
4. Put one oval washer (30) on each carriage bolt (29) and push through
the bores from the top and fasten from the bottom with washers (32),
the spring washers (33) and the hand grip nut (34).
(Note. The position adjusted in this way should always be equal at both
sides. The positions can be change as desired at all times by removing
the carriage bolts (29) and sliding the footrests on the footrest brackets.)
Step 3:
Installation of the right and left handgrip (41) on the handlebar post (19)
with the grip axle (44).
1. Put one spring washer (14) and one washer (23) on screw (24) and screw
tightly on one end of the grip axle (44).
2. Push the wave washer (37) onto the grip axle (44) and then push the grip
axle (44) step by step through the right hand grip (41R), handlebar post
(19) and left hand grip.
(Note. The handgrips are heavier at the top than at the bottom. Twist the
handgrips downwards until further installation is conducted.)
3. Push one spring washer (14) and one washer (23) onto the second screw
(24) and tighten the screw (24) at grip axle (44) firmly.
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Christopeit BLUE T2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Christopeit BLUE T2 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info