632324
11
Zoom out
Zoom in
Previous page
1/16
Next page
hot water system the unvalved radiator(s) on the gravity circuit must
have an output of at least 1.25 kW. This is to prevent boiling in case
of pump failure. All pipework in the primary circuit must be 28 mm
diameter and the gravity flow pipe must rise continuously from the
boiler to the open vent. Two typical systems are shown in Figures 5
and 6.
If the appliance is used to heat a small central heating system then the
heat output to the room from the fire will be reduced.
Fitting a radiator in the same room as the fire is recommended as it
will allow greater flexibility in the way that the system is operated as
well as ensuring that there is sufficient heat.
Connect the heating system to the boiler ensuring that the primary
flow pipe rises continuously from the appliance to the vent. Fill the
system with water and check for leaks.
The circulating pump may be controlled by means of time switches,
room thermostats or outdoor thermostats. Radiators may be either
manually or thermostatically controlled. These controls will all work
in conjunction with the thermostat on the appliance and the low limit
pipe thermostat.
We recommend fitting a pipe thermostat onto the gravity return to
act as a low limit thermostat This should be wired into the mains
supply to the pump so that if the gravity return temperature drops
below 45°C then the pump will cut out. This will help to prevent
condensation forming on the boiler faces and will thereby increase the
life of the boiler. It will also ensure that priority is given to the
SYSTEM CONTROLS
Register Plate
With Soot Door
Alternative
Soot Door Positions
Fig. 11. Horizontal Register Plate With Optional
Vertical Rear Flue Connector
197mm
Register Plate
With Soot Door
Alternative
Soot Door Positions
Fig. 10. Horizontal Register Plate With Top Flue Connection
Register Plate
With Soot Door
Alternative
Soot Door Positions
Fig. 9. Horizontal Register Plate With Rear Flue Connection
Register Plate
Soot Door
In Side or Rear
Of Chimney
Fig. 8. Vertical Register Plate With Bricked Up Fireplace
INSTALLATION INSTRUCTIONS
®
charnwood
I S L A N D
11
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood Island 3B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Island 3B in the language / languages: English as an attachment in your email.

The manual is 0,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Charnwood Island 3B

Charnwood Island 3B User Manual - Dutch - 17 pages

Charnwood Island 3B User Manual - Dutch - 17 pages

Charnwood Island 3B User Manual - French - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info