Manual Charnwood Island 3B (page 5 of 16) (English)

632324

Zoom out

Zoom in

1/16

just one control to be used. The balance between primary and

secondary air for particular flue conditions is pre-set using the sliding

control mounted on the thermostat box beneath the stove. Once set

this should not need to be adjusted.

When burning wood, ash should be allowed to build up and only

riddled when the ash begins to cover the slots in the rear fireplate.

The fire should be riddled with the doors shut (see Fig. 2). Place the

tool onto the riddling lever and rotate between the 1 o'clock and 3

o'clock positions several times. Too much riddling can result in

emptying unburnt fuel into the ashpan and should therefore be

avoided. After riddling, the grate should be put back into the open or

closed position as required (the tool should be in the 1 o'clock

position for open grate or in the 5 o'clock position for closed grate).

Keep the firebox well filled but do not overfill to prevent fuel from

spilling over the top of the front fire bar. Logs should be evenly

distributed, filling the firebed to give the most pleasing flame pattern.

Care should be taken, especially when burning wood, that fuel does

not project over the front fire bar or damage to the glass may be

caused when the doors are closed. It can also cause the glass to

blacken. Maximum filling height is such that logs cannot fall from the

fire when the doors are opened. Liquid fuels are not to be used on

this appliance.

The ashpan should be emptied regularly before it becomes too full.

Never allow the ash to accumulate in the ashpan so that it comes in

contact with the underside of the grate as this will seriously damage

the grate bars. The ashpan is handled using the tool provided. Care

should be taken to ensure that ash is cool before emptying it into

plastic liners or bins.

To make ash removal easier there is a special Charnwood ash carrier

available. This may be purchased from your supplier or, in case of

difficulty, from ourselves.

For correct firing we recommend the use of a stove pipe

thermometer which may be purchased from your supplier or from

ourselves.

RIDDLING

REFUELLING

ASH CLEARANCE

Open Position

Closed Position

Riddle

Fig. 2. Multifuel Grate

the fuel is well ignited then load with fuel. Once the fire is up to

temperature the airwash system will begin to work, so allow the fire

to become hot before adjusting the thermostat to the required

setting.

On initial lighting, the stove may smoke and give off an odour as the

silicon paint with which the firebox is painted reacts to the heat. This

is normal and will cease after a short time, but meanwhile the room

should be kept well ventilated.

At first only light a small fire and burn it slowly for two hours to allow

any residual moisture in the bricks to evaporate.

When relighting the stove, riddle slightly and then empty the ashpan.

The fire is controlled by the water temperature thermostat. The

water temperature is set by the control knob shown in Fig. 1. Turn

the knob clockwise to increase the water temperature or anti-

clockwise to decrease.

This thermostat controls both primary and secondary air, enabling

CONTROLLING THE FIRE

Fig. 3. Secondary air Adjustment

OPERATING INSTRUCTIONS

charnwood

I S L A N D

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Island 3B in the language / languages: English as an attachment in your email.

The manual is 0,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Charnwood Island 3B

Charnwood Island 3B User Manual - Dutch - 17 pages

Charnwood Island 3B User Manual - French - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Charnwood Island 3B Manual

Product: