Manual Charnwood Bay BX (page 6 of 20) (English)

815476

Zoom out

Zoom in

1/20

LIGHTING

On initial lighting, the stove may smoke and give off an odour as the

silicon paint with which the firebox is painted reacts to the heat. This

is normal and will cease after a short time, but meanwhile the room

should be kept well ventilated. At first only light a small fire and burn

it slowly for two hours to allow any residual moisture in the chimney

to evaporate.

Light the stove using dry kindling wood and paper or fire lighters. It is

recommended that you use approximately 1kg to 1.2kg of kindling.

Put the paper, or fire lighters, and kindling in the firebox and cover

with a few small dry logs. Open the air control fully (see Fig. 2). Light

the paper or fire lighters. The door may be left cracked open for a

few minutes to assist the combustion and heat up the firebox more

quickly.

When the kindling wood is well alight add a few more small logs and

close the door, but leave the air control fully open. When the flames

are established around the smaller logs, load the stove with larger

logs to the required fuel load. Logs should be no more than 75mm in

diameter and 480mm long. Close the door. Maintain the air control

at maximum at this stage.

Once long flames appear over the fire, reduce the air control to the

‘high output’ setting. Once the fire is well established - with each log

alight at the top - the air setting can be reduced again, depending on

the type of fire required. If at any stage the flames start to go out or

the glass begins to discolour, a higher setting is required. To achieve

this, open the air control to re-establish a consistent burn.

Once the fire is up to temperature the airwash system will begin to

work, so allow the fire to become hot before adjusting the air control

to the required setting. During the lighting period, do not leave the

stove unattended. Do not leave the door open except as directed

above to avoid excessive smoke.

When relighting the stove, leave the ash on the base unless it is

becoming too deep, in which case some of it may be removed.

Keep the firebox well filled but do not allow fuel to spill over the top

of the fuel retainer.

Logs should be evenly distributed, filling the firebed to give the most

pleasing flame pattern. The air control must be fully opened after

REFUELLING

OPERATING INSTRUCTIONS

Fig. 3 Initial firing

Fig. 4 Building up the fire

Fig. 5 Adding larger logs

Fig. 6 Fire well underway

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Bay BX in the language / languages: English as an attachment in your email.

The manual is 2.38 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Charnwood Bay BX Manual

Product: