815476

Charnwood Bay BX Manual

5
Zoom out
Zoom in
Previous page
1/20
Next page
Take care not to touch the doors as they will be hot when the fire is
burning. Pull the door handle up to open, and push down to close.
The stove should be run with the door shut.
The rate of burning and hence the output is controlled by the air
control (see Fig. 2).
Open the air control fully when lighting or when rapid burning is
required. It should not be left fully open for long periods as this can
cause over-firing or excessive smoke production. For high output
move the air control to the ‘High Output’ position’ or for low
burning to the fully closed position.
CONTROLLING THE FIRE
When the fire is burning normally the air control gives enough
airwash to keep the glass clean. However, it will not always be
possible to keep the glass clean with the air control fully closed.
Congratulations on becoming the owner of a Charnwood Bay BX
Stove It is very important that you read and understand these
instructions before using the stove.
DOOR OPERATION
The door handle has been carefully designed so that in normal use it
may be operated using bare hands. However, if you need to open the
doors when the fire is running at maximum, then the use of the glove
provided may be required
.
FUEL
Before lighting the stove check with the installer that the work and
checks described in the Installation Instructions have been carried out
correctly and that the chimney has been swept, is sound and free
from any obstructions. The stove is not suitable for use in a shared
flue system.
Remember that the stove will be hot and that it is made from hard
materials – ensure that you have good balance before operating the
fire. Always use the provided operating tool and gloves.
Do not use an aerosol spray on or near the stove when it is alight.
There is a risk of explosion or flash ignition of the spray.
When using the stove in situations where children, aged and/or
infirm persons are present a fireguard must be used to prevent
accidental contact with the stove. The fireguard should be
manufactured in accordance with BS 8423:2002.
The stove is suitable for intermittent operation.
Only dry well seasoned wood should be burnt on this appliance as
burning wet unseasoned wood will give rise to heavy tar deposits in
the stove, on the glass and within the chimney. For the same reason
hard woods (such as Ash, Beech and Oak) are better than soft woods
(such as Pine and Spruce). Burning wet unseasoned wood will also
result in considerably reduced outputs. The wood should be cut and
split and then left to season in a well ventilated dry place for at least
one year but preferably two years before use. Approximate suitable
log sizes are:
480mm long and 75mm diameter
PETROLEUM COKE IS NOT SUITABLE FOR USE ON
THIS APPLIANCE. ITS USE WILL INVALIDATE THE
GUARANTEE.
This stove is not designed to burn household waste.
®
OPERATING INSTRUCTIONS
5
Fig. 1 Stove controls
Air control Fuel retainer Door handle
1
2
34
Air control handle
Fig. 2 Air control
1. Slumber
2. Medium Output
3. High Output
4. Boost
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood Bay BX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Bay BX in the language / languages: English as an attachment in your email.

The manual is 2.38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info