Manual Chamberlain Motorlift 1000 (page 18 of 112) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

474155

Zoom out

Zoom in

1/112

The force, as measured on the closing edge of the door,

should not exceed 150 N (15kg). If the closing force is

adjusted to more than 150 N, the Protector System must be

installed. Do not use the force adjustments to compensate

for a binding or sticking garage door. Excessive force will

interfere with the proper operation of the Safety Reverse

System or damage the garage door.

Fasten the caution label adjacent to the lighted door control

button as a reminder of safe operating procedures.

Disengage all existing garage door locks to avoid damage

to garage door.

Install the lighted door control button (or any additional push

buttons) in a location where the garage door is visible,

but out of the reach of children. Do not allow children to

operate push button(s) or remote control(s). Serious

personal injury from a closing garage door may result from

misuse of the opener.

Activate opener only when the door is in full view, free of

obstructions and opener is properly adjusted. No one

should enter or leave the garage while the door is in

motion. Do not allow children to play near the door.

Use manual release only to disengage the trolley and, if

possible, only when the door is closed. Do not use the red

handle to pull the door open or closed.

Disconnect electric power to the garage door opener

before making repairs or removing covers.

This product is provided with a power supply cord of special

design which, if damaged, must be replaced by a power

supply cord of the same type; such a power supply cord

may be obtained from your local Chamberlain distributor and

must be fitted by a specialist.

START BY READING THESE IMPORTANT SAFETY RULES

These safety alert symbols mean Caution – a personal safety or property damage instruction. Read these instructions carefully.

This garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict

accordance with the following safety rules.

Failure to comply with the following instructions may result in serious personal injury or property damage.

Caution: If your garage has no service entrance door, Model 1702EML Outside Quick Release must be installed. This accessory allows

manual operation of the garage door from outside in case of power failure.

CONTENTS

SAFETY RULES: Page 1

DOOR TYPES: Page 1 – Illustration

TOOLS REQUIRED: Illustration

HARDWARE PROVIDED:

Page 1 – Illustration

BEFORE YOU BEGIN: Page 2

COMPLETED INSTALLATION:

Page 2 – Illustration

ASSEMBLY: Page 2 – Illustrations –

INSTALLATION:

Pages 3-4 – Illustrations –

PROGRAMMING THE CODE:

Page 4 – Illustration

ADJUSTMENT:

Pages 4-5 – Illustrations –

INSTALL THE PROTECTOR :

(Optional): Page 5 – Illustration

OPERATION OF YOUR OPENER: Page 5

CARE OF YOUR OPENER: Page 5

MAINTENANCE OF YOUR OPENER: Page 6

PROBLEMS: Page 6

ACCESSORIES: Page 7 – Illustration

SPECIFICATIONS: Page 7

RAIL ASSEMBLY & INSTALLATION

PARTS LIST: Illustration

OPENER PARTS LIST: Illustration

Keep garage door balanced. Sticking or binding doors

must be repaired. Garage doors, door springs, cables,

pulleys, brackets and their hardware are under extreme

tension and can cause serious personal injury. Do not

attempt to loosen, move or adjust them. Call for garage

door service.

Do not wear rings, watches or loose clothing while

installing or servicing a garage door opener.

To avoid serious personal injury from entanglement,

remove all ropes connected to the garage door before

installing the door opener.

Installation and wiring must be in compliance with your

local building and electrical codes. Connect the power

supply cord only to properly earthed mains.

Lightweight doors or fiberglass, aluminum or steel

must be substantially reinforced to avoid door

damage. (See page 4.) The best solution is to check with

your garage door manufacturer for an opener installation

reinforcement kit.

The safety reverse system test is very important. Your

garage door MUST reverse on contact with a 50mm

(obstacle placed on the floor. Failure to properly adjust the

opener may result in serious personal injury from a closing

garage door. Repeat the test once a month and make

any needed adjustments.

This unit should not be installed in a damp or wet

space.

Door must not extend over public byway during

operation.

HARDWARE PROVIDED –

Assembly Hardware:

(1) Washered Screws (2)

(2) Hex Screws (2)

(3) Nuts (2)

(4) Lock Washers (2)

(5) Master Links (2)

(6) Carriage Bolts (12)

(7) Lock Nuts (12)

(8) Trolley Threaded

Shaft (1)

(9) Clevis Pin (1)

Installation Hardware:

(10) Carriage Bolts (2)

(11) Wood Screws (4)

(12) Screws (2)

(13) Clevis Pins (2)

(14) Hex Screws (5)

(15) Rope

(16) Handle

(17) Insulated Staples

(18) Anchors (2)

(19) Lock Washers (8)

(20) Nuts (9)

(21) Ring Fasteners (3)

(22) Rail Grease

(23) 8mm Anchors (4)

(24) Sheet Metal

Screws (2)

DOOR TYPES –

1-GB

A. One-Piece Door with Horizontal Track Only

B. One-Piece Door with Horizontal and Vertical Track – Special door arm

(F, The Chamberlain Arm™) required. See your dealer.

C. Sectional Door with Curved Track – See B – connect door arm.

D. Double-wing door – Special door arm required. See your dealer.

E. Canopy door – Special door arm (F, The Chamberlain Arm™)

required. See your dealer.

114A2360E

tenho à vários anos um Chamberlain Motorlift 1000,só hoje é que deixou de trabalhar não obedece ao
telecomando .Não sei o que aconteceu.Os telecomandos estão a funcionar bem.Será que a placa electrónica ou o motor estão avariados.Diga-me da sua Justiça.
Nada mais tenho a dizer,envio meus cumprimentos. Submitted on 31-5-2021 at 17:52
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Chamberlain Motorlift 1000 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,24 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Chamberlain Motorlift 1000 Manual

Product: