555413
7
Zoom out
Zoom in
Previous page
1/22
Next page
Wear protective goggles when working overhead to protect your eyes from injury.
Disengage all existing garage door locks to avoid damage to the garage door.
To avoid serious personal injury from entanglement, remove all ropes connected to the garage door before
installing the opener.
Note: It is recommended that the opener be installed no less than 2.1m above the floor where space permits.
3
1
2
4
Header Bracket Positioning
The header bracket must be rigidly fastened to a
structural support of the garage. Reinforce the
wall or ceiling with a 40 mm (1-1/2") board if
necessary. Failure to comply may result in
improper operation of safety reverse system.
You can attach the header bracket either to the
header wall (1) or to the ceiling (3). Follow the
instructions which will work best for your particular
requirements.
With the door closed, mark the vertical centerline (2)
of the garage door. Extend line onto header wall
above the door.
Open door to highest point of travel. Draw an
intersecting horizontal line (4) on header wall 5 cm
(2") above high point to provide travel clearance for
top edge of door.
12
7
3
1
4
2
6
3
2
8
5
4
3
2
6
1
Install Header Sleeve and Tighten Belt
Slide header sleeve (1) onto rail (5). Slide flat washer (3), spring (2) and washer (3) onto carriage bolt (4). Thread nut (6)
onto carriage bolt until finger tight. Use an open end wrench (7) to tighten nut until the belt is approximately 2mm above
the base of the rail at its midpoint. DO NOT OVER TIGHTEN THE BELT. See image (8).
11
INSTALLATION SECTION
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chamberlain ML750 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chamberlain ML750 in the language / languages: English as an attachment in your email.

The manual is 2,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Chamberlain ML750

Chamberlain ML750 User Manual - English, German, Dutch, French, Italian - 46 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info