555395
28
Zoom out
Zoom in
Previous page
1/60
Next page
en
Planning
You may find it helpful to refer to the applicable
illustration as you proceed with the installation of
your garage door operator and The Chamberlain
Arm™. The garage door opener must be installed
parallel to the floor.
Follow rail assembly instructions as shown in the
Owner's manual. For fitting rail with canopy arm
use this manual.
6
8
3
12
2
9
13
11
7
14
15
5
10
1
17
4
Canopy Door with Structural Obstruction and
4 rail sections
Garage Door with Dual Tracks – (vertical and
horizontal)
1. Header wall
2. Header bracket
3. Garage door opener rail
4. Ceiling
5. Garage door opener
hanging brackets
6. Trolley
7. Extension arm
8. Garage door
9. Garage door spring
10. Operator
11. Garage door opener
manual release
12. Chamberlain Arm™
13. Garage door track
14. Garage door, should
be horizontal in fully
open position
15. Use limit adjustment of
garage door opener to
level the garage door
PICTURE 1
Header Bracket Installation
For a canopy door, the instructions (Figures 2A& 2B)
replace Step 13 in the Owner’s manual which refer to
positioning the header bracket. If you have an inward
facing lintel, which does not allow the header bracket
to be fitted directly above the garage door, you should
refer to step Garage door with inward protruding lintel.
For dual track doors, install the header bracket
50mm (2”) above the high point of door travel as
shown in the Owners manual.
Standard canopy garage doors
Canopy doors are normally provided without a frame,
for fixing to a timber frame. In this case, ensure header
bracket is located as shown below:
113.5 mm
17 mm
1
2
3
4
5
5
3
7
If the door has a lip,
measure from
the top of the door,
not the top of the lip.
17 mm
41 mm
1
2
6
3
4
For pre-hung canopy garage doors
For doors either pre-hung in a metal frame or supplied
with a metal frame for self-assembly, ensure header
bracket is located as shown below:
1. Header bracket
2. Header frame
3. Top of Garage Door
4. Door jamb
5. Garage Door
6. Pre-hung door with frame
7. Lip
PICTURE 2A
PICTURE 2B
15
6
8
3
2
11
7
5
10
1
4
12
13
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chamberlain 1703 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chamberlain 1703 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 8,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info