24
The battery for your Shimano Di2 system mounts inside
the down tube using the Internal Battery Mount (MT-BINT)
designed to t this frame. As this is a sealed location, it is
important to test the system prior to nal installation.
Insert a long 5mm hex key into the
lower end of the holder to work as an
insertion tool.
Pass the battery and holder assembly
through the opening in the bottom bracket
shell and position it, in the down tube, so
that the xing nuts are located over the
mounting holes.
Press the two M3 xing nuts
into the holder through the
upper holes. Attach battery
to mount using two zip ties,
and install.
Ensure Loctite 242 is applied to the M3
xing screws. Pass through the mounting
holes to catch the xing nuts in the battery
holder, tightening only slightly to hold in
place. Remove 5mm hex key. Using 2mm
hex key, tighten xing screws to maximum
of 2.5Nm over the mounting holes.
M3 x 16mm screws
DI2 BATTERY INSTALLATION
1. Install shifters on handlebar.
2. Place brake housing and E-Wires in the
before the stem).
3. Attach handlebar to stem, and attach brake
instructions.
before the stem.