646182

Caterchef 309.003 - U1 Manual

27
Zoom out
Zoom in
Previous page
1/44
Next page
- 27 -
ENGLISH
Maintaining the heating elements
Due to the high electrical load and lime-rich water found in many areas, it is common for limescale to form on the
heating elements. This has a detrimental effect on heat conduction. This is why it is necessary to maintain and clean
the dishwasher regularly and to use a water softener!
Remove any limescale residue on the bottom of the reservoir. If in doubt, contact your dealer.
Maintaining the water pipes
Impurities in the water inlet hose (strainer) must be removed regularly to ensure a constant fl ow of water.
Service
If repairs or other adjustments are necessary, please contact your dealer or service company.
13. Detecting malfunctions
This section could help prevent the need to call out a repair service. If a problem persists after all possible causes
have been checked, contact your dealer or a qualifi ed service company.
Problem Possible causes & proposed solution
The machine will not
work
First check that the power and water supplies are switched on and working correctly!
Open the door and close it again, then press the Start button, and if it doesn’t work:
1. There may be a blown fuse or activated circuit breaker in the meter cupboard.
2. Check if the internal fuse has blown. Switch off the power!
3. Check that the rinse arms can spin, remove dirt etc. regularly.
Long wash cycle
1. The temperature in the boiler and/or reservoir is too low. (See the display)
2. Check the fi lter gauze in the water inlet pipe, and clean if necessary.
3. If there is too much limescale residue (consult dealer), use a water softener!
Plates are not clean
1. Remove left-over food thoroughly before washing up, use a pre-rinse spray
2. The water pressure may be too low due to a blockage in the inlet strainer pump in the
reservoir. Disconnect the power supply, empty the reservoir, inspect it and clean the
strainer, etc, remove any food remains.
3. The water temperatures may be too low. Not enough warming up time after it has
been turned on: Check the temperatures in the display panel.
4. Incorrect dose of detergent. Contact your detergent supplier or your dealer.
5. Descaling may be necessary, use a water softener!
6. The plate racks may not be loaded correctly.
Spots and stains
on cutlery,
glasses and plates
1. The baskets are not loaded correctly.
2. Incorrect rinse water temperature (See display).
3. Low water pressure caused by an obstructed pump (clean regularly).
4. Extremely hard water use a water softener!
5. Incorrect detergent for the type of water. (detergent supplier)
6. Incorrect rinsing agent for the type of water. (detergent supplier)
7. Incorrect concentration of detergent and rinsing agent. (detergent supplier)
Water does not fi ll up
or only does so slowly
Foreign objects prevent the water supply from working properly.
Note: this must be checked after installation. Iron particles from the water pipe may get
stuck in the hose. Disconnect the water supply. Remove the hose from the tap. Clean the
fi lter and put it back. This problem could also occur if the water pressure in the water inlet
is too low.
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Caterchef 309.003 - U1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Caterchef 309.003 - U1 in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info