543646
14
Zoom out
Zoom in
Previous page
1/19
Next page
E-13
Getting Ready
8. On the “Image Shaping” menu that appears, select “Adjust Image Position” and
then press the [ENTER] key.
z This will project two adjustment patterns, a yellow one for Projector A and a light blue one for
Projector B.
z Use the focus rings of Projector A and Projector B to adjust the focus of the patterns as required.
Important!
Important!
Important!
z All of the explanations in this manual assume that Projector A is connected by HDMI cable to
OUTPUT A of the Control Box and that Projector B is connected to OUTPUT B, as shown under
“Wiring” (page E-7). Reversing these connections will cause the adjustment pattern colors to be
reversed (light blue for Projector A, yellow for Projector B).
9. Observe the adjustment patterns as you adjust Projector A and then Projector B.
Try to achieve the characteristics described below as you make adjustments.
z Adjust so the horizontal crosshairs of the adjustment patterns are horizontal.
z Adjust so the vertical lines of the adjustment pattern crosshairs are in the center of the screen.
10.
On the Control Box remote controller, press the [BLANK] key.
z This will cause the Projector B adjustment pattern to disappear, leaving only the Projector A
adjustment pattern (yellow).
11.
While observing the Projector A adjustment pattern, perform the vertical
adjustments described below.
z Adjust the vertical orientation of the cabinet.
z Adjust the zoom ring of Projector A.
The crosshairs of the adjustment pattern should be in the center
of the target screen and the outer border of the adjustment
pattern should be just outside of target projection area, as
shown in the nearby figure.
12.
Press the remote controller’s [BLANK] key.
z This will project from Projector B again so the adjustment patterns of both Projector A and
Projector B are being projected.
13.
Perform the steps below to get the adjustment pattern of Projector B as closely
aligned as possible with the Projector A adjustment pattern.
z Take care simply to loosen the five screws. Do not remove them.
14.
After the adjustment is the way you want, press the [ESC] key.
z This will cause the Projector A and Projector B adjustment patterns to disappear, and project the
“Image Shaping” menu.
Projector A : Use the same procedure as that in step 3 to fine tune the adjustment of the
Projector A adjustment pattern.
Projector B : Use the same procedure as that in step 5 to fine tune the adjustment of the
Projector B adjustment pattern.
(1) Adjust the zoom ring of Projector B.
(2) Loosen the five screws that secure the cabinet side panels (see the illustration under step 5,
above), and then rotate the adjuster knob to adjust the orientation.
(3) After position adjustment is complete, fully tighten the screws.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio XJ-SK600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio XJ-SK600 in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio XJ-SK600

Casio XJ-SK600 User Manual - German - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info