543646
12
Zoom out
Zoom in
Previous page
1/19
Next page
E-11
Getting Ready
Use the procedure in this section to adjust the projected images of the two projectors so they are
approximately the same size and at the same position on the target screen (the screen, wall, or other
surface to be used as the projection surface after setup of the Projector System is complete).
z After you finish configuring the initial settings of the Control Box, perform the procedure below.
z For information about which projector is Projector A and which one is Projector B, see “Wiring” (page
E-7).
To adjust the positions of the two projectors
1. If you shut off power after finishing the procedure under “To configure initial Control
Box settings” (page E-10), turn on Control Box power.
Adjustment 1: Rough alignment of the two projection screens
2. Attach the lens cover to the lens of Projector B only so only the Projector A image is
being projected on the projection screen.
3. Perform the steps below to adjust the position and size of the Projector A image so
it slightly runs off the edges of the target screen, as shown in the “After adjustment”
image above.
4. Remove the lens cover from the lens of Projector B so its image is projected.
Adjusting the Positions of the Two Projectors
Perform the operations below using the Control Box remote controller (YT-200). Note that these
operations cannot be performed using the projector remote controller (YT-120).
3
Before adjustment After adjustment
(1) Move the cabinet to change its orientation.
(2) Adjust the zoom ring of Projector A.
Target screen
Projector B image
Projector A image
Target screen
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio XJ-SK600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio XJ-SK600 in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio XJ-SK600

Casio XJ-SK600 User Manual - German - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info