624853
15
Zoom out
Zoom in
Previous page
1/26
Next page
Note
If Barometric Pressure Change
Indications are on, barometric
pressure readings are taken every
two minutes even while the watch is
not in the Barometer Mode.
Barometric Pressure Change
Indications turn off automatically 24
hours after it is turned on.
Time signal reception is disabled
while Barometric Pressure Change
Indications are turned on. Power
saving is also disabled.
l
Power Saving Function
You will not be able to turn on
Barometric Pressure Change
Indications are while charge level of
the watch’s battery is low.
Low battery power will also cause
barometric pressure trend
information to turn off.
Calibrating Barometric
Pressure Readings
The watch’s pressure sensor is adjusted at the
factory and normally does not require
calibration. However, you can calibrate the
displayed value if you notice major errors in
readings.
Important!
The
watch will not be able to produce
correct temperature readings if you
make a mistake during the
calibration procedure. Check to
make sure that the value you use for
calibration produces correct
pressure readings.
1.
Pull out the crown.
Crown
2.
Rotate the crown to change the value.
Calibration Unit: 1 hPa (0.05 inHg)
To return the barometric pressure
setting
to its initial factory default, press
(A) and (C) at the same time.
3.
Push the crown back in to complete the
setting operation.
Specifying the Barometric
Pressure Measurement Unit
You can specify either hectopascals (hPa) or
inches
of mercury (inHg) as the display unit for
barometric pressure values.
Important!
When Tokyo (TYO) is set as the
Home City, the barometric pressure
unit is fixed as hectopascals (hPa)
and cannot be changed.
1.
Pull out the crown.
Crown
2.
Press (B).
3.
Rotate the crown to select hectopascals
(hPa) or inches of mercury (inHg) as the
measurement unit.
4.
Push the crown back in to complete the
setting operation.
Barometric Pressure
Reading Precautions
The barometric pressure graph produced
by
this watch can be used to obtain an idea
of upcoming weather conditions. However,
this watch should not be used in place of
precision instruments required for official
weather prediction and reporting.
Pressure sensor readings can be affected
by sudden changes in temperature.
Because
of this, there may be some error in
the readings produced by the watch.
Temperature
Measurement
The watch can be used to take current air
temperature readings.
Important!
Check the information below to find
out how to ensure correct readings.
l
Temperature Reading Precautions
Getting ready
Enter the Temperature Mode.
l
Navigating Between Modes
Thermometer Mode
Entering the Temperature Mode starts
temperature readings.
Checking the Current
Temperature
Entering the Temperature Mode displays
temperature reading results. After you enter
the Temperature Mode, the watch takes
readings about every five seconds for three
minutes. After that, a measurement is taken
about every two minutes.
To retrigger measurement, press (A).
Note
The watch will automatically return
to the Timekeeping Mode if you do
not perform any operation in the
Temperature Mode for about one
hour.
The measuring range is -10.0 °C to
60.0 °C (14.0 °F to 140.0 °F) (0.1 °C
(0.2 °F) units). [- - .-] will appear for
the measured value if it is outside the
allowable range.
To
return to the Timekeeping Mode,
hold down the (B) button for about
two seconds.
Operation Guide 5470
15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio 5470 - PRW-6100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio 5470 - PRW-6100 in the language / languages: English as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio 5470 - PRW-6100

Casio 5470 - PRW-6100 User Manual - German - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info