Manual Carrera Digital 124 - 23613 GENTLEMEN RACE (page 17 of 26) (English, German, French)

550542

Zoom out

Zoom in

1/26

4 65

ATTENTION! Depending on the model, the light boards might be

screwed tight.

Front light: To change the light boards unscrew the car’s upper

part from the chassis. Unscrew the front axle according to ﬁg.

and remove the cables between the front light and the car board (ﬁg.

). Slightly bend down the catch hook (ﬁg.

) and pull up the light

board. Insert the light board (ﬁg.

), until the catch hook latches

in. Screw in the front axle and ﬁt the cables together according to

their colours.

Rear light: Remove the cables between the rear light and the car

board according to ﬁg.

Slightly bend down the catch hook (ﬁg.

) and pull up the light board. Insert the light board until the catch

hook latches in (ﬁg.

) and ﬁt the cables together according to

their colours.

Maintenance and care

To ensure a proper operation of the motor-racing circuit, all race-

track components should be regularly cleaned. Pull the plug prior to

cleaning.

Racetrack: Keep the track surface and track slots clean with a

dry cloth. Do not use any solvents or chemicals for cleaning. When

it is not in use, store the racetrack in a clean and dust-protected

location, preferably in the original cardboard box.

Car check: Clean axle and wheel bearings, pinion gears, gear-

wheels and bearings and lubricate using a resin- and acid-free

grease. You can use a toothpick or similar as aid. Regularly check

the condition of sliding contacts and tyres..

Troubleshooting

Driving tips

Troubleshooting:

In case of any malfunctions, please check the following:

• Has the connection to the power supply been established cor-

rectly?

• Have transformer and speed controllers been connected correctly?

• Are the track connections faultless?

• Are the racetrack and track slots clean and free of any foreign

objects?

• Are the sliding contacts in order and do they make contact with

the track slot?

• Are the cars correctly coded to the according speed controller?

• The track‘s current feed will be switched oﬀ automatically for 5

seconds, if there is an electrical short circuit: this will be notiﬁed by

audible and visual signals.

• Are the cars placed on the track in running direction? In case of

non-functioning push the running direction switch which is on the

car´s bottom.

• Is the adapter unit correctly installed facing the direction of travel?

• Is the speed controller battery properly connected?

• Is the battery fully charged?

• Does the LED on the controller ﬂash while charging?

• Is the speed controller bound to the receiver?

• Has the speed controller got a duplicate address assignment?

Note:

During operation small car parts as spoilers or mirrors may get oﬀ or

brake due to being original detailed parts of the car model. To avoid

this it is possible to remove them before operation.

Driving technique:

• You can drive fast along the straight track but you should brake

before the curve and then accelerate again when coming out of the

curve.

• Do not fasten or block the vehicles when the motor is running:

overheating or damage to the motor could result otherwise.

Note: When using track systems which are not manufactured by

Carrera the existing guide keel has to be replaced by the special

guide keel (#85309). While using the Carrera crossing (#20587) or

high banked curve 1/30° (#20574) slight driving noise might occur

which is due to the full-scale genuineness and does not aﬀect ﬂaw-

less operation.

All Carrera spare parts are available in the webshop:

carrera-toys.com

Delivery exclusively to Germany, Austria, Netherlands, Belgium and

Luxembourg.

Technical specifications

Output voltage: Toy transformer

18 V 54 VA

Lithium polymer rechargeable battery: 3,7 150mAh

Electricity modes:

1.) Operating mode = cars are operated via speed controllers

2.) Idle mode = speed controllers not activated, no game

3.) Stand-by mode = after approx. 20 minutes idle mode the

connecting section switches to stand-by mode. LED ﬂashes at

long intervals. CURRENT CONSUMPTION < 0.5 watt / 0.5w

By operating the speed controller the stand-by mode is ﬁnished,

the racetrack returns to idle-mode again.

4.) Oﬀ-state = power supply unit disconnected from mains supply

This device is marked by “selective sort throught” symbol related to

sort through domestic, electric and electronic, waste. This means

the product must be treated by a specialized “sorting/collecting” sys-

tem in accordance with European directive 2002/96/CE, to reduce

the impact upon environment. For more precise information, please

contact your local administration. Electronical product which are

not going through special collecting, are potentially dangerous for

environment and human health, because of dangerous substance.

Output voltage: Toy transformer

18 V 54 VA

Lithium polymer rechargeable battery: 3,7 150mAh

Electricity modes:

1.) Operating mode = cars are operated via speed controllers

2.) Idle mode = speed controllers not activated, no game

3.) Stand-by mode = after approx. 20 minutes idle mode the

connecting section switches to stand-by mode. LED ﬂashes at

long intervals. CURRENT CONSUMPTION < 1 watt / 1w

By operating the speed controller the stand-by mode is ﬁnished,

the racetrack returns to idle-mode again.

4.) Oﬀ-state = power supply unit disconnected from mains supply

Requirement for FCC Part 15

Warning: Changes or modiﬁcations not expressly approved

by the party responsible for compliance could void the user’s

authority to operate the equipment.

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instruc-

tions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in

a particular installation.

If this equipment does cause harmful interference to radio or televi-

sion reception, which can be determined by turning the equipment

oﬀ and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver,

• Connect the equipment into an outlet on a circuit diﬀerent

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

Warnings

Guidelines and warnings about using the LiPo battery/

batteries:

LiPo rechargeable batteries are much more sensitive than the

traditional alkaline or NiMh rechargeables. For this reason all in-

structions and warnings must be scrupulously observed. Incorrect

treatment of LiPo rechargeable batteries may cause a ﬁre. In han-

dling, charging and using the LiPo battery/batteries supplied, you

take over all responsibility for the risks attached to lithium batteries.

• Non-rechargeable batteries must not be recharged!

For recharging batteries, only the charging cradle supplied may be

used. If this instruction is disregarded, there is a risk of ﬁre which

may endanger your health and/or cause damage to property.

NEVER use any other charging unit!

• Rechargeable batteries may only be recharged under adult super-

vision. When charging, never leave the battery unattended.

When you recharge the battery, you should always be in the vicinity

to keep watch on the process so that you can react to any possible

problem.

• If the battery swells or deforms during either discharge or charging

process, stop the process immediately. Remove the battery as fast

and as carefully as possible and place it on a safe and open area

away from any ﬂammable materials, and keep it under observation

for at least 15 minutes. If you continue to charge or discharge a bat-

tery which has already started to swell or deform, there is danger of

ﬁre! Even at the slightest sign of swelling or deforming, the battery

must be taken out of service.

• The battery supplied must be charged in a safe place away from

ﬂammable materials.

• Store the battery at room temperature (16 - 18 °C) in a dry place.

Do not expose the battery to direct sunlight or any other sources of

heat. Temperatures over 50 °C are generally to be avoided.

• Always recharge the battery after use to avoid the possibility of its

becoming deep discharged. When it is not in use, recharge the bat-

tery from time to time, say every 2-3 months. Failure to observe the

methods of handling described above may lead to defects.

• When changing batteries do not use any sharp or pointed objects

or tools. Avoid damaging the protective foil around the battery at

all costs.

• When replacing defective batteries, only the recommended battery

types may be used. Damaged or unusable batteries are hazardous

waste, and must be disposed of accordingly.

• Never throw batteries, rechargeable or otherwise, on the ﬁre or

expose them to high temperatures. This may cause a ﬁre or an

explosion.

• The electrolyte and electrolyte vapour in the LiPo batteries are

hazardous to health. Always avoid direct contact with electrolyte.

If electrolyte makes contact with skin, eyes or other parts of the

body, it must immediately be washed out or oﬀ with plenty of fresh

water and a doctor must be consulted.

• Rechargeable batteries are not toys and must not fall into the

hands of children. Keep batteries inaccessible to children.

• The connector clips / battery connections must never be short-

circuited!

• The toy is only to be operated with a transformer or power pack

designed for use with toys!

• The transformer / the power pack is not a toy!

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Carrera Digital 124 - 23613 GENTLEMEN RACE in the language / languages: English, German, French as an attachment in your email.

The manual is 9,18 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Carrera Digital 124 - 23613 GENTLEMEN RACE Manual

Product: