806102

Carina Junior Manual

35
Zoom out
Zoom in
Previous page
1/80
Next page
34
For safety, it is strongly suggested you turn
off the power before threading.
a. Spool pin holder
1. Start by raising the needle to its highest
point, and continue turning the handwheel
counterclockwise until the needle just
slightly begins to descend. Raise the
presser foot to release the tension discs.
Place the thread and spool pin felt (a) onto
the spool pin.
2. Draw thread from spool through the thread
guide to the upper thread guide.
3. Thread tension module by leading thread
down right channel and up left channel.
During this process it is helpful to hold the
thread between the spool and thread guide.
4. At the top of this movement pass thread
from right to left through the slotted eye of
the take-up lever and then downwards
again.
5. Now pass thread behind the thin wire
needle clamp guide and then down to the
needle which should be threaded from front
to back.
6. Pull about 6-8 inches of thread to the rear
beyond the needle eye. Trim thread to
length with built in thread cutter.
Note:
Par mesure de sécurité, nous vous
conseillons vivement de mettre la machine
hors tension avant de procéder à lenfilage.
Nota:
a. Feutre de cannet
1. Poser une bobine de fil sur la tige porte
bobine.
2. Faire passer le fil dans le premier guide
(de droite à gauche) puis descendre le
fil dans la fente de droite.
3. Remonter le fil dans le guide la fente
de gauche.
4. Passer le fil dans le guide fil (de droite
à gauche). Si celui-ci n'est pas visible, il
suffit tourner le volant jusqu'à ce qu'il
apparaisse.
5. Tirer le fil vers le bas de maniére a le
passer dans le guide situé juste au
dessus de l'aiguille.
6. Recoupez le fil à longueur au moyen
du coupe-fil intégré.
NB:
Schakel de naaimachine veiligheidshalve uit
voor u met het inrijgen begint.
a.Viltkussen
1. Garenklos op de garenkloshouder zetten.
2. Garen door de geleider naar voren tussen
de draadspanningsschijven.
3. Dan naar beneden en naar links onder de
geleider, daarna
4. naar boven en van rechts naar links over
de draadhevel leggen en naar voren
trekken.
5. Garen naar beneden in de draadgeleider
aan de naaldhouder en van voor naar
achter door het oog van de naald trekken.
6. Trek garen uit het oog van de naald. Snijd
het garen ob de gewenste lengte af met
de ingebouwde garensnijder.
Bovendraad Inrijgen
NL
Enfiler le fil supérieur Threading the upper thread
EN
FRFR
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carina Junior at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carina Junior in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0.57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info