709292
209
Zoom out
Zoom in
Previous page
1/231
Next page
209
Troubleshooting
Nearby electronic devices
- If the transmission rate over a Wi-Fi network drops because of interference from the following electronic devices,
switching to the 5 GHz band or to a different channel may solve the problem.
- Wi-Fi networks using the IEEE 802.11b/g/n protocol operate in the 2.4 GHz band. For this reason, the transmission
rate may drop if there are nearby microwave ovens, cordless telephones, microphones, or similar devices operating on
the same frequency band.
- If another access point operating on the same frequency band as the camcorder is used nearby, the transmission rate
may drop.
Using multiple camcorders/wireless transmitters/access points
-Check that there are no IP address conflicts among the devices connected to the same network.
- If multiple XF705 camcorders are connected to a single access point, connection speeds may be r
educed.
- To reduce radio wave interference when there are multiple access points using IEEE 802.11b/g or IEEE 802.11n (in the
2.4 GHz band), leave a gap of four channels between each wireless access point. For example, use channels 1, 6, and
11, channels 2, 7, and 12, or channels 3, 8, and 13. If you can use IEEE 802.11a/n (in the 5 GHz band), switch to IEEE
802.11a/n and specify a different channel.
List of Messages
Refer to this section if a message appears on the screen. The messages in this section appear in alphabetical
order. Note that for some messages, an indication of the card involved (SD card A, SD card B, or both) may
appear above the message itself.
Accessing SD Card A/SD Card B Do not remove
- You opened the card slot cover while the camcorder was accessing the card. Close the card slot cover.
Battery communication error. Does this battery display the Canon logo?
- You attached a battery pack that is not recommended by Canon for use with this camcorder.
-If you are us ing a battery pack recommended by Canon for use with this camcorder, there may be a problem with the
battery pack or camcorder. Consult a Canon Service Center.
Buffer overflow. Recording was stopped.
- The data transfer rate was too high for the card in use and the recording was stopped. Use a recommended card
(A 33).
Cannot play back
- The card contains clips that were recorded using a system frequency different from the one currently used by the
camcorder. To play back the recordings on the card, change the > [! Recording/Media Setup] > [System
Fr
equency] setting to match the recordings on the card.
- The file control information is corrupted or there was a decoder error. Turn the camcorder off and then on again. If this
does not solve the problem, consult a Canon Service Center.
Cannot switch SD card slots
-The SLOT SELECT button was pressed while the camcorder is recording. Wait until recording is finished to change the
selected SD card slot.
Change the battery pack
- The battery pack is exhaus ted. Replace or charge the battery pack.
Cover is open
-The SD card slot cover was open when the camcorder was switched to or turned on in mode. Insert a card
and close the card slot cover.
Fan error
- The cooling fan may not be working properly. Consult a Canon Service Center.
File name error
- You attempted to record a clip while clip numbers are at their maximum value. Save your clips (A 151)
and initialize
the card (A 35) or delete all the clips (A 140).
- You attempted to take a photo while photo numbers are at their maximum value. Set > [" Recording/Media
Setup] > [Photo Numbering] to [Reset] and delete all the photos on the card (A 182) or initialize it (A 35).
INFRARED switch position changed (ON/OFF). Check the focus.
-The focus may change when you turn the infrared mode on or off. Check that the focus is correct.
209


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canon XF705 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canon XF705 in the language / languages: English as an attachment in your email.

The manual is 17,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Canon XF705

Canon XF705 User Manual - German - 238 pages

Canon XF705 User Manual - Dutch - 229 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info