709292
204
Zoom out
Zoom in
Previous page
1/231
Next page
Troubleshooting
204
Troubleshooting
If you have a problem with your camcorder, refer to this section. Consult your dealer or a Canon Service Center
if the problem persists.
Power source
The camcorder will not turn on or it turns off by itself.
- The battery pack is exhausted. Replace or charge the battery pack.
- Remove the battery pack and reattach it correctly.
Shortly after turning it on, the camcorder turns off on its own.
-You are using a battery pack that is not compatible for use with this camcorder. Use a recommended battery pack
(A 219).
Cannot charge the battery pack.
- The temperature of the battery pack is outside the charging range. If the battery packs temperature is below 0 °C
(32 °F), warm it before charging it; if it is above 40 °C (104 °F), let the battery pack cool down before charging it.
- Charge the battery pack in temperatures between 0 °C and 40 °C (32 °F and 104 °F).
- The battery pack is faulty. Replace the battery pack.
The battery pack is exhausted extremely quickly even at normal temperatures.
-Check the [Battery/Hour Meter] status screen (A 201) to check if the battery pack has reached the end of its battery
li
fe. If so, buy a new battery pack.
Recording
The camcorder’s controls are not responsive/disabled.
- When the KEY LOCK switch is set to
C
, all buttons (or all buttons with the exception of some REC buttons) are locked
and cannot be operated. Set the KEY LOCK switch to . You can change which controls are locked with the
> [$ System Setup] > [Key Lock] setting (A 193).
Pressing the REC button will not start recording.
-The SD card is full or it already contains the maximum number of clips (999 clips). Delete some clips (A 140) or save
your clips (A 151) and initialize the card (A 35) to free some space. Alternatively, replace the card.
- The REC button that was used may be disabled. Change the current settings in the
> [$ System Setup] >
[Camera Grip REC Button] setting to enable the use of the REC button on the grip.
- The camcorder may be set to a special recording mode. If the special recording mode is no longer necessary, return
> [! Recording/Media Setup] > [Recording Mode] to [Normal Recording] to end the special recording
mode.
- You may not be able to start or stop recording while controls on the optional RC-V100 Remote Controller are being
operated. Stop using the remote controller and then press the REC button.
The point where the REC button was pressed does not match the beginning/end of the recording.
-There is a slight interval between pressing the REC button and the actual start/end of recording. This is not a
malfunction.
The camcorder will not focus.
- The camcorder may not be able to focus on certain subjects using autofocus. Focus manually (A 74).
- When the AF mode is set to AF-boosted MF, start focusing manually until the AF frame changes to white (automatic
adjustment range).
- The viewfinder is not adjusted. Use the dioptric adjustment lever to make the proper adjustment (A 28).
-The lens is dirty. Clean the lens with a sof
t lens-cleaning cloth.
When a subject flits across in front of the lens, the image appears slightly bent.
-This is a phenomenon typical of CMOS image sensors. When a subject crosses very quickly in front of the camcorder,
the image may seem slightly warped. This is not a malfunction.
Abnormal images appear on the screen and the camcorder cannot record properly.
- While recording using an almost empty battery pack together with the compact power adapter, the compact power
adapter was inadvertently disconnected or the power supply was suddenly interrupted. Reconnect the compact
power adapter and turn the camcorder off and then on again or replace the battery pack with a fully charged one.
204


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canon XF705 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canon XF705 in the language / languages: English as an attachment in your email.

The manual is 17,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Canon XF705

Canon XF705 User Manual - German - 238 pages

Canon XF705 User Manual - Dutch - 229 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info