683263
193
Zoom out
Zoom in
Previous page
1/215
Next page
193
Troubleshooting
Memory card cover was opened so network functions will be interrupted.
- The SD card compartment cover was opened while the SD card was being accessed. Stop the Wi-Fi function in use
and end the network connection.
Multiple access points detected. Try the operation again.
- There are multiple access points sending out a WPS signal at the same time. Try the operation again later or perform
setup using the [WPS: PIN Code] or [Search for Access Points] option (A 146).
Network connection terminated
- An error occurred on the access point or connected device. Check the network or connected and try connecting
again.
- The Wi-Fi signal became too weak and the wireless connection was lost. Wait a moment or turn off other devices in
the area that may be interfering with the Wi-Fi signal and then try connecting again.
Network is not working correctly
- There’s a hardware problem with the camcorder’s network related circuitry. Try turning the camcorder off and the on
again. If the problem persists, consult a Canon Service Center.
No access points found
- The camcorder searched for active Wi-Fi networks (access points) in the area but none were found. Make sure the
access point is working correctly and try connecting again.
- The access point is operating in stealth mode. Deactivate the stealth function in the wireless router (access point)
settings.
- The connection wizard may not be able to find the access point if MAC address filtering is activated. Check the
[Network Settings 1/9] status screen (A 181) and make sure to add the camcorder’s MAC address to the list of
approved wireless devices in the wireless router (access point) settings.
No files available for transfer.
- All the files selected for transfer have already been transferred to the FTP server.
Unable to complete WPS.
- The access point’s encryption method is set to [WEP]. Wi-Fi Protected Setup (WPS) cannot connect to access points
set to this encryption method. Change the access points encryption method or use another connection method
(A 146).
Unable to complete WPS. Try the operation again.
- More than 2 minutes passed between activating WPS on the access point and selecting [OK] on the camcorder. Start
over the WPS procedure from the beginning.
- The WPS button was not held down long enough. Refer to the instruction manual of your wireless router. When using
WPS to make a wireless connection, keep the WPS button held down until the wireless router’s WPS function is
activated.
Unable to connect
- Could not connect to the access point or network device selected.
- Cordless phones, microwave ovens, refrigerators and other appliances may interfere with the wireless signal. Try using
the camcorder in a location farther away from such appliances.
Unable to obtain an IP address
- If you are not using a DHCP server, connect using the [Manual] option and enter the IP address using the [Manual]
option (A 150).
- Turn on the DHCP server. If it is already on, make sure it is functioning properly.
- Make sure the address range for the DHCP server is sufficient.
- If you are not using a DNS server, set the DNS address to [0.0.0.0].
- Set the DNS server’s IP address in the camcorder.
- Turn on the DNS server. If it is already on, make sure it is functioning properly.
- Make sure that the DNS server’s IP address and the name for that address are correctly configured.
- If you are using a wireless gateway router, make sure all of the devices in the network, including the camcorder, are
configured with the correct gateway address.
Wi-Fi authentication unsuccessful
- Check the access points authentication/encryption method and encryption key and change the camcorder’s Wi-Fi
settings (A 152) as necessary.
Wi-Fi cannot be used while the wireless microphone is attached.
- Wi-Fi connections cannot be used while an optional WM-V1 Wireless Microphone is attached to the camcorder.
Disconnect the WM-V1 from the camcorder and turn it off.
Wi-Fi error. Incorrect authentication method
- Check the access points authentication/encryption method and change the camcorder’s Wi-Fi settings (A 152) as
necessary.
193


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canon EOS C100 Mark II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canon EOS C100 Mark II in the language / languages: English as an attachment in your email.

The manual is 16,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Canon EOS C100 Mark II

Canon EOS C100 Mark II User Manual - German - 223 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info