683263
191
Zoom out
Zoom in
Previous page
1/215
Next page
191
Troubleshooting
Fan error
- The cooling fan has stopped working or may not be working properly. Consult a Canon Service Center.
File name error
- The folder and file numbers have reached their maximum value. Set [Other Functions]
> [File Numbering] to [Reset]
and delete all the MP4 clips (A 132) and photos (A 166) on the SD card or initialize it (A 42).
Invalid operation
- The following operations cannot be performed.
In mode, immediately reviewing a recording made using pre-recording.
Pressing the START/STOP button when there is no SD card in the camcorder.
Lens error Turn the camcorder off, then on again.
- There was a communication error between the camcorder and the lens. Turn the camcorder off and then on again.
Lens firmware update Firmware update failed. Try updating again.
- The lens's firmware could not be correctly updated. Try updating the lens's firmware again.
May not be possible to record movies on this memory card
- You may not be able to record video on an SD card without a speed class rating or rated SD Speed Class 2 or 4.
Replace the SD card with one rated SD speed class 6 or 10.
Media full
- SD card A and SD card B are full. Delete some clips (A 132) or photos (A 166) to free some space or replace one or
both SD cards.
Media is almost full
- The amount of available space on SD card A and SD card B combined is low. Replace one or both SD cards.
Memory card is write-protected
- The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch.
No clips
- There are no clips on the SD card to play back. Clips must be recorded (A 47) in order to play them back.
No photos
- There are no photos on the SD card to play back. Photos must be taken (A 163) in order to view them.
Number of clips already at maximum
- The SD card selected for recording already contains the maximum number of AVCHD clips (3,999 clips). Replace the
SD card or use the SD card in the other SD card slot.
- Because both SD cards reached the maximum number of clips, double slot recording is not available.
During double slot recording, both “8A” and 8B” will appear in the message.
Number of shots already at maximum
- You have already recorded the maximum number of shots (3,999 shots) in a single SD card. When using two SD cards,
you cannot record additional shots on either SD card. To add more shots, replace the SD card(s).
Number of shots in this clip already at maximum
- You have already recorded the maximum number of shots (950 shots) in a single continuous recording clip.
Continuous recording can continue but you cannot record additional shots. To add more shots, stop the continuous
recording to record a clip and then start recording a new continuous recording clip (A 99).
Pre Rec was canceled. Activate Pre Rec again?
- Pre-recording was deactivated automatically after the camcorder was left in record pause mode for about 1 hour with
pre-recording activated. Select [On] and then press the joystick to activate pre-recording again.
Pre Rec will be canceled in a moment.
- The camcorder has been in record pause mode for about 1 hour with pre-recording activated. Pre-recording will be
deactivated automatically in approximately 1 minute.
Reached the recording limit for one clip. Recording was stopped.
- When recording a single clip for an extended period of time, the clip will be split into smaller video files every 4 GB.
This message will appear when the number of smaller video files reaches 50.
Recorded at 50.00 Hz/59.94 Hz Check the data on 8A/8B Initializing the card is also recommended
- The SD card contains clips that were recorded using a recording type (system frequency) other than the one currently
used by the camcorder. To record on this SD card, save your clips (A 143) and initialize the SD card (A 42). To play
back the recordings on the SD card, set [w Other Functions] > [System Frequency] to [59.94 Hz] or [50.00 Hz] as
necessary, so the camcorder matches the SD card.
191


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canon EOS C100 Mark II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canon EOS C100 Mark II in the language / languages: English as an attachment in your email.

The manual is 16,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Canon EOS C100 Mark II

Canon EOS C100 Mark II User Manual - German - 223 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info