624614
25
Zoom out
Zoom in
Previous page
1/106
Next page
22 23
PART I
b. Adjusting the cam-and-cup mechanism (fig. 8B)
The cam-and-cup system on your front wheel will
have been correctly adjusted for your bicycle by your
dealer. Ask your dealer to check the adjustment every
six months. Do not use a cam-and-cup front wheel
on any bicycle other than the one for which your
dealer adjusted it.
3. Removing And Installing Wheels
WARNING
IF YOUR BIKE IS EQUIPPED WITH A HUB BRAKE
SUCH AS A REAR COASTER BRAKE, FRONT OR
REAR DRUM, BAND OR ROLLER BRAKE; OR
IF IT HAS AN INTERNAL GEAR REAR HUB, DO
NOT ATTEMPT TO REMOVE THE WHEEL.
The removal and re-installation of most hub
brakes and internal gear hubs requires special
knowledge. Incorrect removal or assembly can
result in brake or gear failure, which can cause
you to lose control and fall.
CAUTION
If your bike has a disc brake, exercise care in
touching the rotor or caliper. Disc rotors have
sharp edges, and both rotor and caliper can get
very hot during use.
a. Removing a disk brake or rim brake front wheel
(1) If your bike has rim brakes, disengage the
brake’s quick-release mechanism to increase the
clearance between the tire and the brake pads
(See Section 4.C fig. 11 through 15).
(2) If your bike has cam action front wheel retention,
move the cam lever from the locked or CLOSED
position to the OPEN position (figs. 8a & b). If
your bike has through bolt or bolt-on front wheel
retention, loosen the fastener(s) a few turns
counter-clockwise using an appropriate wrench,
lock key or the integral lever.
(3) If your front fork has a clip-on type secondary
retention device, disengage it . If your front fork
has an integral secondary retention device, and a
traditional cam action system (fig. 8a) loosen the
tension adjusting nut enough to allow removing
the wheel from the dropouts. If your front wheel
uses a cam-and-cup system, (fig. 8b) squeeze
the cup and cam lever together while removing
the wheel. No rotation of any part is necessary
with the cam-and-cup system.
You may need to tap the top of the wheel with
the palm of your hand to release the wheel from
the front fork.
b. Installing a disk brake or rim brake front wheel
CAUTION
If your bike is equipped with a front disk brake,
be careful not to damage the disk, caliper or
brake pads when re-inserting the disk into the
caliper. Never activate a disk brake’s control lever
unless the disk is correctly inserted in the caliper.
See also Section 4.C.
(1) If your bike has cam action front wheel retention,
move the cam lever so that it curves away from
the wheel (fig. 8b). This is the OPEN position. If
your bike has through bolt or bolt-on front wheel
retention, go to the next step.
(continued on next page...)
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cannondale 2011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cannondale 2011 in the language / languages: English as an attachment in your email.

The manual is 3,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cannondale 2011

Cannondale 2011 User Manual - German - 104 pages

Cannondale 2011 User Manual - Dutch - 104 pages

Cannondale 2011 User Manual - French - 104 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info