Manual Candy CSF 4590 E (page 7 of 15) (English)

621257

Zoom out

Zoom in

1/15

Dishwasher detergent is corrosive! Take care to keep it out

of reach of children.

IF THE WATER ISN'T TOO HARD, YOU MAY ALSO PREVENT THE FORMATION OF DEPOSITS BY ADDING DETERGENT.

The amount of detergent needed can vary due to differences in water hardness. To determine the water hardness in your area,

contact your local water utility or area water softening company. The harder the water, the more detergent you may need.

Remember, you should adjust the amount of detergent you use by small amounts until you find the correct amount.

To remove hard water spots, try the following:

Run dishes through a normal wash program.

Remove all metal dishware, such as cutlery, pans, etc.,

from the dishwasher.

Do not add detergent.

Pour two cups of vinegar into a bowl and set the bowl face

up on the lower rack of the dishwasher.

Runthe dishes through a normal wash program.

If this doesn't work, try the same process with 1 / 4 cup of

citric acid crystals instead of vinegar.

Use only detergent specifically made for use in dishwashers.

Keep your detergent fresh and dry. Don't put powder detergent

into the dispenser until You're ready to wash dishes.

The rinse aid is released during the final rinse to prevent water

from forming droplets on your dishes that can leave spots and

streaks. It also improves drying by allowing water to "sheet" off

the dishes.

Your dishwashers are designed to use liquid rinse aids. The

rinse aid dispenser is located inside the door next to the

detergent dispenser. To fill the dispenser, open the cap and

pour the rinse aid into the dispenser until the level indicator

turns completely black. The dispenser holds about 100 ml of

liquid rinse aid.

Be careful not to overfill the dispenser, because this could

cause oversudsing. Wipe away any spills with a damp cloth.

Don't forget to replace the cap before you close the dishwasher

door.

If you have soft water, you may not need rinse aid for it may

cause a white film to develop on your dishes.

YOU MAY NOT ADD TOO MUCH DETERGENT TO PREVENT THE FORMATION OF DEPOSITS BECAUSE YOUR DISHWASHERS

HAVE SPECIALLY-DESIGNED WATER SOFTENERS.

The dispenser must be refilled before the start of each wash cycle following the instructions provided in the" Wash Cycle

Table".Your dishwashers than conventional dishwashers. Generally, only one tablespoon of

detergent is needed for a normal wash load. Also, more heavily soiled items need more detergent. Always add the detergent just

before starting dishwasher, otherwise it could get damp and will not dissolve properly.

use less detergent and rinse aid

To open the dispenser, turn the cap to the "open" (left)

arrow and lift it out.

Pour the rinse aid into the dispenser, being careful not to

overfill.

Replace the cap by inserting it aligned with "open" arrow

and turning it to the closed (right) arrow.

A measured amount of rinse aid is released during the final rinse. As with detergent, the amount

of rinse aid needed for your dishes depends on the hardness of the water in your area. Too much

rinse aid can result in lather of foaming and cause cloudiness or steaks on your dishes. If the

water in your area is very soft, you may not need rinse aid. If you do,you can dilute the rinse aid

with an equal amount of water.

The rinse aid dispenser has six settings. Always start with the dispenser set on " 1 ". If spots and

poor drying are problems, increase the amount of rinse aid dispensed by removing the dispenser

lid and rotating the dial to "2". If the dishes still are not drying properly or are spotted, adjust the

dial to the next higher number until your dishes are spot-free. We suggest you to set on "4" .

If only four settings we suggest you to set on "2".

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Candy CSF 4590 E in the language / languages: English as an attachment in your email.

The manual is 2,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Candy CSF 4590 E Manual

Product: