764897
21
Zoom out
Zoom in
Previous page
1/24
Next page
THUNDER BAY SE
Preparation and filling the spa
Preparation and Filling
Fill the spa to its correct operating level. Be sure to open all valves and jets in the plumbing system before lling to allow as much
air as possible to escape from the plumbing and the control system during the lling process.
After turning the power on at the main power panel, the top-side panel display will go through specic sequences. These
sequences are normal and display a variety of information regarding the conguration of the hot tub control.
Mode – Ready and Rest
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that performs this function is known
as the “heater pump.” The heater pump is a 2-Speed Pump.
The heater pump is a 2-Speed Pump 1, READY Mode will circulate water every 1/2 hour, using Pump 1 Low, in order to maintain
a constant water temperature, heat as needed, and refresh the temperature display. This is known as “polling.”
REST Mode will only allow heating during programmed lter cycles. Since polling does not occur, the temperature display may not
show a current temperature until the heater pump has been running for a minute or two.
Circulation Mode
If the spa is congured for 24HR circulation, the heater pump generally runs continuously. Since the heater pump is always
running, the spa will maintain set temperature and heat as needed in Ready Mode, without polling.
In Rest Mode, the spa will only heat to set temperature during programmed lter times, even though the water is being ltered
constantly when in Circulation Mode.
Flip (Invert Display)
Note: Some panels may have a dedicated FLIP button, which
allows the user to  ip the display with a single button-press.
The FLIP menu/functionality depends on Manufacturer
conguration and may not be available. (Menu Style 1)
General Messages
Water Temperature is Unknown
After the pump has been running for 1 minute, the temperature
will be displayed.
Safety Trip - Pump Suction Blockage* – M033
The Safety Trip error message indicates that the vacuum
switch has closed. This occurs when there has been a suction
problem or a possible entrapment situation avoided. (Note: not
all spas have this feature.)
(21)
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canadian Spa Company Thunder Bay SE - KH-10030 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canadian Spa Company Thunder Bay SE - KH-10030 in the language / languages: English as an attachment in your email.

The manual is 11,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info