Manual Canadian Spa Company St Lawrence (page 7 of 32) (English)

764889

Zoom out

Zoom in

1/32

Owners Manual

Locating your hot tub/spa

INDOOR LOCATION

Considerations for selecting an indoor spa location:

• Local building codes for indoor installation of a portable spa

• Adequate space for spa with accessibility for service (Clearance

of 3 ft (1m) around the spa is recommended to permit servicing

the unit)

• Proper structural support is critical. Consult a licensed

professional Structural Engineer to determine if the foundation

will adequately support the spa the entire time it will be in place,

especially if the spa is to be placed on a second story or higher,

balcony, roof or other platform not speciﬁcally tied into the main

structural support.

• Proper ventilation (Consult an Engineer or authority who

understands the necessary provisions to vent moist or heated air

and air with chemical odours. When the spa is in use

considerable amounts of moisture escapes, potentially causing

mould and mildew which can damage certain surfaces and

surroundings.

POSITIONING YOUR HOT TUB/SPA

When selecting a site for your spa, take into account the following:

A) Local Codes:

There may be certain restrictions and/or requirements that are

particular to your locality. If in doubt, check with your local council.

B) Delivery Passageway:

The spa will arrive as a unit, and cannot be disassembled. Ideally the

spa will be placed on a trolley, either on its side or on its base. The

unit will then be rolled into place easily crossing grass, gravel, and

small terrain anomalies. For safe and non-intrusive installation, we

require an opening not less than the width of your spa (see dealer

for current sizes) plus at least 40cm in height for the trolley and a

minimum of 5cm clearance on each side for adequate access. If

your access does not meet these conditions, or in the case of other

obstacles (steps, fences, walls, steep hills, etc.) contact Canadian Spa

Company for advice and conditions.

C) Location & Base:

A sheltered environment can result in lower operating and

maintenance costs. You must allow 1 metre clearance for access to

the spa’s access panel for servicing.

• The site you select for your spa MUST be a ﬂat, level continuous

surface that fully contacts the bottom of the spa.

• Your new spa weighs between 300-450kg when dry, and when

ﬁlled to capacity weighs 900-2300kg. Therefore a solid support

is essential when the spa is mounted on a deck or ground level

patio/ﬂoor. We recommend that you install your spa at ground

level. This allows easy access to equipment.

• A 10 to 15cm thick re-enforced concrete slab is ideal, but not

essential. In most cases your spa can be placed on properly

installed existing patios.

• The base must be at least the size of the bottom of your spa (see

dealer for current sizes).

• Water should always drain away from the spa. DO NOT locate

your spa in a low run-off area since melting snow or rain could

ﬂood the area and cause pump and equipment damage.

• DO NOT situate the spa near or under overhead wires and keep

clear of all electrical appliances.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Canadian Spa Company St Lawrence in the language / languages: English as an attachment in your email.

The manual is 3,07 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Canadian Spa Company St Lawrence

Canadian Spa Company St Lawrence User Manual - German - 32 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Canadian Spa Company St Lawrence Manual

Product: