Manual Camry CR 7929 (page 7 of 132) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish)

802432

Zoom out

Zoom in

1/132

Reason: The device is not placed on a flat surface. So, put the device on a flat and hard place to reduce noise.

Reason 4: Air-inlet or air out-let is blocked. So, remove blockage.

If nylon filter (12) is clogged with dust, then the effectiveness of the device is reduced, be sure to clean the filter once every two weeks.

Reason 2: Door and windows are open , many heat sources in the room. So, close the door and windows, move out heat sources.

Problem II.: The device auto-restarts frequently.

TROUBLESHOOTING

Reason1: Direct sunlight. So, drawn the curtains.

1.Pull out drainage plug (8) to flow out water.

- Force down from the outside the latch of filter frame (11) with hands and pull out to yourself to remove the filter frame(11).

4.Clean and dry filters, then reinstall them.

Storage the device and all device components in dry place.

Problem I.: The air conditioning does not work.

3.Turn off the device and pull out plug .

Reason 2: The water full indicator light “N” is illuminated. So, discharge the water.

Reason 1:There is no electricity. So, turn it on after connecting it to a socket with electricity.

Reason 3: Filters are too dirty. So, clean or replace filters.

Problem III.: Big Noise

Reason: Compressor time-delay protection turn on. So, wait for 3 minutes until the temperature is lowered, and then restart the device.

- Put nylon filter (11) into warm water with neutral detergent (about 40℃ / 104℉) and dry it in the shade after rinsing clean.

Problem IV.: Compressor does not work.

- Clean the upper and down filters frame (11) after remove both nylon filters (12) from the filter frame(11). – picture G.

If the device will be unused for a long time, please do as following :

6.Put the device into plastic bag , and place it on a dry place.

STORAGE

5.Pull out exhaust pipe for safe keeping .

2.Let the device runs under fan mode for 2 hours to dry out the device's internal.

7.Remove batteries of the remote control and keep them properly.

1.Compressor protection: Three minutes later after power on / restart, compressor starts to run.

Button "G" - press it to set up or cancel timer.

4. During drainage, the body can be tilted slightly backwards.

Button "F" - press it to select fan speed in sequence: slow / fast wind speed.

Clean with surface of device with a wet soft cloth. Don't use chemicals, such as benzene, alcohol, gasoline, otherwise, the surface of the

device will be damaged or even the whole device will be damaged.

b) Net nylon filters cleaning

Button "E" - press it to set up or cancel sleep mode.

a) Housing cleaning

This device is equipped in auto-water-evaporating system. Condensed water cycle will cool down the condenser, which will not only

improve cooling efficiency, but also save energy.

2. Power off the device.

3. Prepare flat container (not included to set) to drain the water. Locate it under the drain hole (8)

3. Remove the rubber cap from the drain hole (8) – picture F.

1. If inner water tank is full, the water full indicator lamp “N” will be illuminated, the device enter into standby mode, buzzer shouts,

compressor stops and all buttons is invalid till the device recovers to be normal, after water drainage.

5. After water stops to pouring out, close the rubber cap (8).

6. Restart the device, the device will runs normally.

Button “H” - press to set up or cancel automatic air oscillation function.

CLEANING & MAINTENANCE

switched on.

Cleaning: before cleaning and maintenance, turn off the device and unplug the plug.

2.Overflow protection function: when the water full indicator lamp “N” will be illuminated and the buzzer will alarm for several second, the

device turn off automatically. In this case, you need to drainage the water (details see Drainage Instructions at the end of this chapter). After

the water is emptied, the device will get into standby status.

PROTECTION DEVICES

3. Frost Protection Function: In cooling mode, if the temperature of the EVA pipe sensor is too low, the device will automatically enter

protection status. When the temperature of the EVA pipe sensor rises to a certain temperature, it can automatically revert to normal

operation.

DRAINAGE INSTRUCTIONS:

Note: when abnormal situations are occurred, turn off device and pull out plug, then contact with professional service for help .

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Camry CR 7929 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 5.92 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Camry CR 7929 Manual

Product: