The barbecue is equipped with a circular connector. It
should be used with flexible hose that is suitable for use with
butane and propane gas. Hose length should not exceed
1.20 metre. It should be replaced if it is damaged or
develops surface cracks or when so required by national
legislation. Do not pull or pierce the hose.
Keep away from any parts of the barbecue that get hot.
Check that the flexible hose stretches out normally,
without twisting or pulling.
The barbecue should be used with flexible tubing that is
suitable for use with butane and propane gas. Hose
length should not exceed 1.50 metre. It should be
replaced if it is damaged or develops surface cracks or
when so required by national legislation. Do not pull or
pierce the tubing. Keep away from any parts of the
barbecue that get hot. Check that the flexible hose
stretches out normally, without twisting or pulling.
Flexible tubing connection: to connect the tubing to the
connector on the barbecue, tighten the nut on the tubing
firmly but without excess force using the two wrenches
provided:
- no. 14 wrench to tighten the connector
- no. 17 wrench to tighten the nut on the tubing
1) Work outside, away from all sources of ignition. Do not
smoke.
2) Make sure the control knobs are in the "off" ( )
position.
3) Connect the flexible tubing to the connector and
barbecue as described in part d).
4) Fit the regulator onto the gas cylinder in accordance
with its instructions.
5) Use a gas leak solution to test for leaks.
never use a naked flame to check for gas leaks.
6) Apply the solution to the connections cylinder/regulator/
hose/apparatus (the control knobs should remain
closed: off position ( )). Open the gas cylinder valve.
7) Bubbles in the gas leak solution indicate that there are
gas leaks.
8) The leak can be stopped by tightening any hose
connection or replacing any faulty component. The
barbecue must not be used until the leak is stopped.
9) Close the valve on the gas cylinder.
Check for leaks at least once per year and each time the
gas cylinder is replaced.
Never use the barbecue until the instructions have been
read carefully and understood. Also, make certain that:
- there are no leaks
- the venturi tubes are not blocked (example: spider
webs)
- the hose does not touch any components which may get
hot.
- that the ventilation openings in the gas receptacle
housing are not obstructed, if appropriate.
- Make sure that the control knob is in the "OFF" position
( ).
- Push the adjustment button down and turn it anti-
clockwise until it is in the full flow position ( ), then
immediately press the ignition button down (
) until you hear a click. Repeat 3 or 4 times if necessary.
- Repeat this operation until the burner lights.
- If the burner does not ignite after 4 or 5 attempts, wait 5
minutes and then repeat the operation.
If the piezoelectric ignition does not function, light the
burners manually (next paragraph).
- Make sure that the control knob is in the "OFF" position ( ).
- Strike a match and bring it close to the burner from
below.
- Push an adjustment button down and turn it anti-
clockwise until it is in the full flow position ( ).
Return the control knob to the "off" position ( ), then close
the cylinder valve.
- Always work in a well ventilated area and never in the
presence of a flame, spark or heat source.
- Return the control knobs in the "off" position ( ) then
close the cylinder valve.
7
