Manual Cadac Carri Chef 50 - 8910 (page 6 of 160) (English, German, Dutch, Danish, French, Italian, Polish, Swedish, Turkish, Spanish, Norwegian, Finnish)

819977

Zoom out

Zoom in

1/160

Lighting the appliance using the piezo

• To light up the appliance using the piezo igniter, push and turn the control knob in an anticlockwise

direction until you hear a click. If the gas does not ignite on the ﬁrst spark, turn the control knob back to its

“OFF” position. Try again, by pushing and turning the control knob anti-clockwise until you hear a click. If

the gas has not ignited in the ﬁrst two to three seconds you should close the control valve by turing

the control knob back to its “OFF” position.

• Wait approximately thirty seconds to let any accumulated gas within the burner escape. Repeat the above

process if necessary until the ﬂame ignites. The ﬂame should normally light up within the ﬁrst one to two

seconds.

Lighting up using a BBQ lighter

• When starting cold, the appliance may be lit from the top prior to ﬁtting the desired cooking surface onto

the fat pan. When lighting up a hot appliance, it is recommended that this be done by sticking a barbecue

lighter through one of the vent holes underneath the burner, until it is in line with the burner (DO NOT

place the BBQ lighter through the large hole directly underneath the burner). Ignite the BBQ lighter. Whilst

the BBQ lighter is lit, push and turn the control knob anti-clockwise to light the burner.

General

• Once the appliance is lit, the ﬂ ame intensity may be adjusted by turning the valve knob anti-clockwise to

reduce the ﬂame, or clockwise to increase the ﬂ ame.

• The fully closed position is at the furthest clockwise position. To rotate the valve from the fully closed

position, it is necessary to ﬁrst press the control knob in just enough to move out of the lock mechanism. While holding the control knob in,

turn it in an anti-clockwise direction. Once the spindle has moved out of the lock position it is no longer necessary to keep the control knob

pressed in and it can be rotated freely to the desired ﬂame setting.

• When cooking food with a high fat content, ﬂaring may occur if the selected heat setting is too high. Should this happen, turn the heat down

until the ﬂaring ceases.

• The ﬂame may be observed through the inspection hole provided for this purpose on the side of the fat pan.

• Aer use, ﬁrst close the control valve on the gas cylinder (if applicable). When the ﬂame has gone out, close the control valve on the device

• Do not move the appliance when in use. It is unsafe practice to move the appliance whilst lit and may cause ﬂaring.

• When not in use remove the gas cartridge

Cooking tips:

A feature of the Skottel BBQ is that it oﬀers various heat zones (See Fig.5). This is very useful as some foods cook quicker than others and the

food that is ready ﬁrst, can be moved to the cooler areas of the dish to keep warm whilst the balance of the food is still cooking.

NOTE! If the appliance is used in windy conditions, the dome must be used as a wind shield, and placed in position (as shown in ﬁg. 6).

Medium Hot Cool

Locators

Fig. 4 Fig.5

Fig. 3

Push & turn le

to ignite.

Fig.6

WIND

Only applicable to

8910-10, 8910-20,

8910-30, 8910-40,

8910-50, 8910-70

& 8910-80

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Cadac Carri Chef 50 - 8910 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5.76 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Cadac Carri Chef 50 - 8910 Manual

Product: