631403

Brother XR27NT Manual

16
Zoom out
Zoom in
Previous page
1/52
Next page
KNOWING YOUR SEWING MACHINE ————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————
—
————————————————————————————————————————————————
—————
15
Memo
● When sewing with fine, cross-wound
thread, use the small spool cap, and leave a
small space between the cap and the spool.
1 Spool cap (small)
2 Spool (cross-wound thread)
3 Space
7
While holding the spool with your right
hand, pull the thread with your left hand,
and then pass the thread under the thread
guide A.
1 Thread guide A
8
Pass the thread under the thread guide
cover from the back to the front.
Hold the thread with your right hand so that
there is no slack in the thread that is pulled
out, and then pass the thread under the thread
guide B with your left hand.
1 Thread guide B
9
Pull the thread to the right, pass it under
the hook of the bobbin-winding thread
guide, and then wind the thread
counterclockwise between the discs,
pulling it in as far as possible.
1 Hook of the bobbin-winding thread guide
2 Pre-tension disk
0
While using your left hand to hold the
thread that was passed through the
bobbin-winding thread guide, use your
right hand to wind the end of the thread
clockwise around the bobbin five or six
times.
a
Pass the end of the thread through the slit
in the bobbin winder seat, and then pull
the thread to the right to cut it.
1 Slit in bobbin winder seat (with built-in cutter)
X The thread is cut to a suitable length.
CAUTION
a
c
b
1
a
● Be sure to cut the thread as described. If
the bobbin is wound without cutting the
thread using the cutter built into the slit
in the bobbin winder seat, the bobbin
may not be wound correctly. In addition,
the thread may become tangled in the
bobbin or the needle may bend or break
when the bobbin thread starts to run out.
a
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother XR27NT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother XR27NT in the language / languages: English as an attachment in your email.

The manual is 18,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info