631397
48
Zoom out
Zoom in
Previous page
1/101
Next page
37
KNOWING YOUR SEWING MACHINE
KENNENLERNEN IHRER MASCHINE
КРАТКОЕ ТЕХНИЧЕСКОЕ ОПИСАНИЕ МАШИНЫ
A
B
1
2
INSERTING THE TWIN NEEDLE
Insert in the same way a single needle is inserted (refer to page 9).
The flat side of the needle should face toward the back and the
rounded side should face toward you.
PLACING THE EXTRA SPOOL PIN
Place the vertical spool pin in the hole found on top of the machine
near the horizontal spool pin. Place the second spool of thread onto
the vertical spool pin as shown in fig. A.
TWIN NEEDLE THREADING
Each needle should be threaded separately.
1. Threading the Right Needle
Follow the same instructions for single needle threading using
the thread from the spool on the extra spool pin. See page 33 for
more details.
2. Threading the Left Needle
Thread the left needle in the same manner that the right needle
was threaded, but do not pass the thread through the thread
guide above the needle before passing it through the eye of the
left needle as shown below in fig. B.
1 Right needle thread passes through this guide.
2 Left needle thread passes in front of this guide.
DOPPELNADEL EINSETZEN
Setzen Sie die Doppelnadel genau wie eine einfache Nadel ein (lesen Sie
dazu Seite 10). Die flache Seite der Nadel sollte nach hinten weisen, und
die runde Seite nach vorn.
SENKRECHTEN GARNROLLENSTIFT ANBAUEN
Setzen Sie den senkrechten Garnrollenstift in die Öffnung in der Nähe des
waagrechten Garnrollenstifts oben auf der Maschine. Setzen Sie die
zweite Garnrolle auf den senkrechten Garnrollenstift, wie in Abb. A
gezeigt.
NÄHEN MIT DOPPELNADEL
Jede Nadel sollte einzeln eingefädelt werden.
1. Fadenführung rechte Nadel
Befolgen Sie die Anweisungen, die für das Nähen mit einem Ober-
faden gelten, benutzen Sie jedoch den Faden vom senkrechten
Garnrollenstift. Siehe Seite 34 für weitere Einzelheiten.
2. Fadenführung linke Nadel
Führen Sie den Faden für die linke Nadel auf die gleiche Weise wie für
den ersten Faden, der zweite Faden soll jedoch nicht durch die
Fadenführung über der Nadel laufen, bevor Sie den Faden durch das
Öhr der linken Nadel fädeln; siehe Abb. B.
1 Faden der rechten Nadel passiert die Führung.
2 Faden der linken Nadel läuft vor der Führung.
УСТАНОВКА ДВОЙНОЙ ИГЛЫ
Данная операция выполняется так же, как и операция
установки нормальной швейной иглы (см, стр. 10). Плоская
сторона иглы должна быть обращена назад, а цилиндрическая
часть - вперед.
УСТАНОВКА ДОПОЛНИТЕЛЬНОГО ВСТАВНОГО КАТУШЕЧНОГО СТЕРЖНЯ
Вставьте вертикальный катушечный стержень в специальное
гнездо, расположенное в верхней части машины рядом с
горизонтальным катушечным стержнем. Установите на
вертикальный стержень вторую катушку с нитками, как
показано на рис. А.
ЗАПРАВКА НИТОК В ДВОЙНУЮ ИГЛУ
Операция выполняется для каждой иглы отдельно.
1. Заправка правой иглы
Выполните те же операции, что и для заправки обычной
иглы, но при этом заправляйте иглу ниткой со вставного
катушечного стержня. Подробное описание заправки иглы
приводится на странице 34.
2. Заправка левой иглы
Операция выполняется аналогично операции заправки
правой иглы с той лишь разницей, что данная нитка минует
нитенаправитель, расположенный непосредственно над
иглой, и направляется сразу в игольное ушко левой иглы,
как это показано на рис. В.
1 Правая игольная нитка проходит через данный
нитенаправитель.
2 Левая игольная нитка проходит спереди
данного нитенаправителя.
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother XL-6040 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother XL-6040 in the language / languages: English as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Brother XL-6040

Brother XL-6040 User Manual - German, Dutch, French - 101 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info