631286
52
Zoom out
Zoom in
Previous page
1/68
Next page
43
Oiling
1. Remove the power supply plug from the outlet.
2. Put 2 to 3 drops of oil at each of the points indicated in fig. A.
3. After oiling, run the machine at a fast speed without thread
installed for a short time.
4. Be sure to wipe any excess oil off the machine.
NOTE:
The machine should be oiled once a week if it is used more than
one hour a day. If the machine is used more often, oil every day.
Sewing machine oil is available from your local sewing machine
dealer or service center.
Do not apply too much oil as it may get on your thread and
fabric.
Cleaning
Removing the Shuttle Hook
1. Remove the needle.
2. Remove the extension table and open the shuttle cover on the
front of the free arm.
3. Take out the bobbin case by opening its latch and pulling it
out from the shuttle race.
4. Slide the latch levers out from the retaining ring to remove the
retaining ring. See fig. A.
5. Remove the hook by grasping its center post of the hook and
pulling it out as shown in fig. B.
Graissage
1. Retirer la fiche d’alimentation de la prise de courant.
2. Mettre 2 ou 3 gouttes d’huile sur chacun des points indiqués
sur la fig. A.
3. Après le graissage, faire fonctionner la machine à grande
vitesse, sans fil, pendant un court instant.
4. Essuyer tout excédent d’huile.
REMARQUE:
Si la machine sert environ une heure par jour, elle doit être huilée
une fois par semaine. Si elle sert plus souvent, elle doit être huilée
chaque jour.
Vous trouverez de l’huile pour machine à coudre chez votre
revendeur ou dans un centre technique.
Ne pad verser trop d’huile car celle-ci pourrait couler sur les dils
ou sur le tissu.
Nettoyage
Comment retirer le crochet de la navette
1. Retirer l’aiguille.
2. Retirer la table d’extension et ouvrir le couvercle de la
navette, devant le bras libre.
3. Sortir le boîtier de la canette en tirant sur la languette
métallique pour le sortir de la coursière.
4. Retirer les pattes de blocage de l’anneau de maintien pour
l’ôter. Voir fig. A.
5. Sortir le crochet en le saisissant par son axe central et en
tirant, comme l’indique la fig. B.
Engrasado
1. Desenchufe la máquina de la toma de corriente.
2. Ponga 2 ó 3 gotas de aceite en cada uno de los puntos señalados
en la fig. A.
3. Después de lubricar la máquina, hágala funcionar rápidamente
un instante y sin hilo.
4. Asegúrese de limpiar cualquier exceso de aceite de la máquina.
NOTA:
Lubricar la máquina una vez por semana si se usa más de una hora
diaria. Si se usa más a menudo, engrasarla cada día. Puede comprar
aceite para máquina de coser a su representante o en el centro
técnico local. No conviene aplicar demasiada aceite ya que podrîa
correr por el hilo y el tejido.
Смазка
1. Выньте вилку сетевого шнура из электрической розетки.
2. Капните по 2–3 капли масла в каждую из точек,
отмеченных на рис. A.
3. После смазывания запустите машину на большой скорости
на короткое время; нити при этом не должны быть
заправлены.
4. Сотрите излишки масла с машины.
ПРИМЕЧАНИЕ:
Машину нужно смазывать раз в неделю, если она используется
более одного часа в день. При более интенсивном
использовании смазывайте машину каждый день.
Смазочное масло для швейной машины можно приобрести у
региональных дилеров швейных машин или в сервисных
центрах.
Избегайте излишнего смазывания, поскольку масло может
попасть как на нить, так и на изделие.
A
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother LS-3125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother LS-3125 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 9,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info