718739
72
Zoom out
Zoom in
Previous page
1/132
Next page
Buttonhole Stitching/Button Sewing
S-18
d
Select stitch .
(Only on models with (Automatic thread
cutting key))
Since the end of the thread will be tied off later, do
not set the machine for programmed thread cutting.
e
Adjust the stitch width so that it is the same as the
distance between the holes in the button.
f
Place the button in the position where it will be sewn,
and lower the presser foot lever.
1 Button
When attaching four-hole buttons, first sew the two
holes closest to you. Then, slide the button so that
the needle goes into the two holes toward the rear of
the machine, and then sew them in the same way.
g
Turn the handwheel toward you (counterclockwise) to
check that the needle correctly goes into the two holes
of the button.
If it seems as if the needle will hit the button, remeasure
the distance between the holes in the button. Adjust the
stitch width to the distance between the buttonholes.
h
Start sewing.
Set the sewing speed controller to the left (so that the
speed will be slow).
The machine automatically stops after sewing
reinforcement stitches.
(Only on models with (Thread cutter button))
Do not press .
i
Use scissors to cut the upper thread and the bobbin
thread at the beginning of the stitching.
Pull the upper thread at the end of the stitching to the
wrong side of the fabric, and then tie it with the bobbin
thread.
j
When you are finished attaching the button, slide the
feed dog position switch, to (to the right as seen
from the rear of the machine) and turn the handwheel
to raise the feed dogs.
CAUTION
When sewing, be sure that the needle does not
touch the button, otherwise the needle may
bend or break.
a
Memo
The feed dogs come up when you start sewing
again.
72


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother Innov-is F410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother Innov-is F410 in the language / languages: English as an attachment in your email.

The manual is 3,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Brother Innov-is F410

Brother Innov-is F410 User Manual - German - 132 pages

Brother Innov-is F410 User Manual - Dutch - 132 pages

Brother Innov-is F410 User Manual - French - 132 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info