536074
30
Zoom out
Zoom in
Previous page
1/33
Next page
IMPORTANTThe child seat can be used with either a lap or a lap and
diagonal seat belt.
The child seat has an adjustable support leg (dia 2a). The smaller the child the
more reclined the seat must be.
The larger the child the more upright the seat must be. To change the position
(if required) slide the support leg out until it engages in the desired position.
To slide the support leg in push the two support leg adjuster buttons and pull
up the support leg (dia 2b). Make sure the support leg is engaged rmly.
Place the child seat rearward facing on the car seat. After installation the gap
between the seat in front and child seat should be a minimum of 10mm.
It must NOT rest against the car seat. If it does then adjust the car seat in front
without making the driver or passenger sit in an uncomfortable position. If not
try another seating position in the car (dia 2c).
Extend the footprop fully by pressing the two release Buttons. Make sure
that the footprop tether brackets are facing forwards and that the straps
are not twisted. Lower the footprop and adjust the height so that it is within
approximately 30mm of the oor (dia 2c). Use the ruler printed on the back
page of this manual to get the correct distance from the footprop to the oor.
2a
2b
2c
2. Installing your child seat (rearward facing) in rear side seat
2d
Slide the loop ends of the tether straps
between the front car seat and back as
shown (dia 2d &
dia 2e). Bring the
hook ends of the tether straps around
the outside of the car seat and feed
through the loops
2
. Snap the hooks
of the tether straps onto the xing rings
on the back of the child seat
3
.
Provisionally tighten the tether straps by
pulling the loose ends downwards
4
.
Pull off sufcient lap and diagonal belt (approx.600 – 900mm). Open the lock-
off arm on the side opposite the seat belt buckle. Pull back the child seat cover
to reveal the crotch strap. Feed the belt through the lock-off belt guide and seat
shell slot (dia 2g), up on to the top face of the seat base, behind the crotch
strap (inset) and down through the slot on the other side of the child seat.
Open the other lock-off arm, feed the seat belt under the lock-off arm and
attach the tongue into the buckle (dia 2h).
2f
2g
Slide the loop ends of the tether straps between the front car seat and back
as shown (dia 2d &
dia 2e). Bring the buckle ends of the tether straps
around the outside of the car seat and feed through the loops
2
. Click the
snap hooks of the tether straps into the metal loops on back of the seat.
Provisionally tighten the tether straps by pulling the loose ends downwards.
2i
Pull all of the seat belt slack through the
child seat ensuring the seat belt is not
twisted (dia 2i). When the belt is as tight
as possible, close the lock-off arms on
BOTH sides of the seat ensuring that they
click into place.
If the buckle now lies in the position
marked as wrong with a
and the seat
belt cannot be correctly tightened (dia 2j),
try another seating position in the car.
Finally tighten the tether straps by pulling
the loose ends downwards (dia 2k)
until the footprop touches the oor. The
footprop must rest on a solid oor – not
on lids of storage boxes or similar.
Once rmly strapped in, test the child seat
by trying to move it back and forth and
side to side. If it seems loose, you must
reinstall until rmly installed.
DO NOT rest the back of the child seat
against the driver or front passenger
seats.
2j
2k
2h
9-25 kg
2e
2
4
3
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Britax-Romer MAX-WAY at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Britax-Romer MAX-WAY in the language / languages: English, Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 15,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Britax-Romer MAX-WAY

Britax-Romer MAX-WAY User Manual - Dutch, French, Italian, Portuguese, Spanish - 33 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info