784606
4
Zoom out
Zoom in
Previous page
1/40
Next page
-4-
Assembly
What’s Included:
The MCX is supplied as far as possible pre-assembled from the factory. You can start
your observations in only a few minutes following these instructions carefully. When
opening the package for the first time, check carefully that all the parts listed below are
included (Fig. 1):
- MCX GoTo Telescope with Fork Mounting (A)
- Computerised Handbox with LED display and coiled (curly) cable (B)
- LED viewfinder (C)
-26mmSuperPlössl(SP)Eyepiece(D)
- Allen key (E)
- Field tripod (F)
Some accessories have been packed separately for protection. Check all boxes for their
contents.
Required batteries:
fortheLEDviewfinder:1x3Vbuttoncell,typeCR2032(C)(includedindelivery)
forthetelescope:8x1.5Vbatteries,typeAA(notincluded)
IMPORTANT NOTE!
Do not use rechargeable AA batteries, as these will not give out the correct voltage for use.
Quick Start Guide
1. Remove the MCX from its packaging and place it on a firm level surface. Insert the
eyepiece (A, Fig. 3) and attach the finder (B, Fig. 3) Make sure these are attached firmly,
but do not overtighten their respective attachment screws (touch tightness will do).
2. Now gently lay the MCX on its side in a stable position (be careful that the telescope
does not roll off the surface) and remove the cover of the battery compartment (C, fig.
4)ontheundersideofthemotorhousing/base.InserteightAAbatteries(notsupplied)
intothebatterycompartment(D,fig.4)on.[notsurethis“on.”isneededintheEnglish
version?]
IMPORTANT NOTE!
When inserting the batteries, pay attention to their correct orientation and polarity.
3. Close the lid and return the telescope to its upright position.
4.(3.)Makesurethatthepowersupplyswitch(P,fig.6)issetto"OFF"onthecontrolpanel
ofthetelescope.Removethehandheldcomputer(19,fig.2)fromitspackaging
andconnectittotheHBXconnector(H,fig.5).Tightentheverticalandhorizontal
clutches(6and9,Fig.2).Removethedustcoverfromthefrontendofthetube.
IMPORTANT NOTE!
The telescope has mechanical end stops in the horizontal and vertical axis to prevent
damage to the telescope. [Please do not attempt to slew the telescope beyond these as this
maycausedamagetothemotorsand/orgearing.]Formoreinformation,refertochapter
"AlignmentoftheMCXtothecelestialpole"onpages19and20.)
5.(4.)Switchthepowersupplyswitch(P,fig.6)onthecontrolpanelofthecomputerto
the"ON"position.OntheLCDdisplayoftheHandboxthecopyrightmessagewill
appearandthen"Initialize...";theoperatingsystemhasnowbootedup.
6.(5.)Thehandheldcomputernowpromptsyoutoenterbasicdataandconfirmeachby
pressing the ENTER key. You can now use the arrow keys to rotate the telescope
up, down, right or left. If you want to change the slewing speed of the telescope,
pressthenumerickeys."9"setsthehighestspeed,"1"setsthelowestspeed.See
page 17 for details.
7.(6.)Tocentreanobject,firstadjusttheLEDviewfinder(seepage11).Usethearrow
keys on the handheld computer to move the telescope until the object is centered
in the center of the eyepiece's field of view. Turn the focusing knob of the telescope
(8,fig.2)tofocusontheobject.
Fig. 3
O
A
O
B
Fig. 5
O
H
Fig. 4
O
C
O
D
Fig. 6
O
P
Fig. 7
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bresser 4701102 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bresser 4701102 in the language / languages: English as an attachment in your email.

The manual is 3.85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bresser 4701102

Bresser 4701102 User Manual - German - 40 pages

Bresser 4701102 User Manual - Dutch - 40 pages

Bresser 4701102 User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info