20
EN 2 / INSTALLING YOUR MACHINE
•
Front transport clamp
(Fig. 2
➀
to
➄
)
➀
Unclip the plinth by pressing simultaneously
on the side knobs and pulling them towards
you.
➁
Unscrew the screw holding the red plastic
«front» clamp.
➂
Remove the front clamp.
➃
Plug the hole left by the clamp with the
remaining plug.
➄
Clip the plinth on again.
Advice:
We would recommend that you keep all
the locking components since these must be
refitted if you must subsequently transport your
machine again.
Information:
Your machine has been scrupulously
checked before it left the factory. You may
therefore notice a little water still remaining in the
tank or the products box.
•CONNECTING TO THE COLD
WATER SUPPLY
Your washing machine can be connected to any
cold water pipe.
Connect the supply hose provided to a threaded
20x27 Ø tap (3/4 BSP) not forgetting to insert the
seal supplied (depending on the model, the hose
may already be fitted with a seal)
(Fig. 3)
.
Water supply:
- Minimum water pressure: 0.1 MPa or 1 bar
- Maximum water pressure: 1 MPa or 10 bars
•DRAINING AWAY THE WASTE
WATER
Connect the hose
(Fig. 3)
:
— Either, temporarily, over a sink or a bathtub.
— Or permanently to a ventilated U-bend.
If your installation does not have a ventilated U-
bend, check that the connection is not sealed. In
fact, to avoid any waste water flowing back into the
machine, you are strongly recommended to leave
an air gap between the machine’s drain hose and
the drainpipe.
In any case, the drain hose bracket must be placed
at a height of 0.80 m to 1.10 m higher than the base
of the machine.
Important :
Ensure that the drain hose is tied
firmly in place with cord to avoid the bracket
coming loose during draining and causing a
flood.
2
➀
➁
➂
➃
➄
0,80 m. min.
1,10 m. max.
0,1 ➞ 1 MPa
1 ➞ 10 bars
3
