159841
8
Zoom out
Zoom in
Previous page
1/12
Next page
8
YOUR SL2 WIRELESS SURROUND LINK
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands
To adapt the surround speaker cable for Jewel Cube
®
speakers
Follow these steps before you connect the provided surround speaker cable to your Jewel
Cube
®
speakers.
1. Loosen the screws on the Jewel Cube
®
speaker adapter so you can insert the two-wire
ends into its terminals.
Insert the plain wire () into the plain terminal.
Insert the red-banded wire (+) into the red terminal.
2. Tighten the screws (Figure 6).
Figure 6
Using the adapter
with a Jewel Cube
speaker
Red terminal
screw
Red band
Jewel Cube
speaker
Adapter
on wire
Using this cable with the adapters attached, follow the steps in “To make the receiver
connections” on page 7. Be sure to match each adapter to the proper speaker, right or left.
What the Status LEDs indicate
On the rear of the SL2 transmitter and receiver, the color of the Status LED indicates how
each unit is functioning. With the power pack plugged in, the LED lights as follows:
Blinking green: when one unit is trying to link to the other.
Solid orange: in sleep mode for low power use when there is no audio signal to
communicate.
Solid green: the receiver and transmitter are communicating with each other.
This green LED stays lit for several minutes after communications cease.
Blinking red: the SL2 receiver is too hot, or there is a problem with the surround speaker
cable connection between the SL2 receiver and the speakers.
For information on how to deal with a blinking red LED, see “Troubleshooting” on page 9.
02_Introduction.fm Page 8 Monday, August 7, 2006 9:53 AM
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bose sl 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bose sl 2 in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info