818577
15
Zoom out
Zoom in
Previous page
1/36
Next page
15
GETTING YOUR HEADSET READY FOR USE
CAUTION: Do not attempt to pull the connector out without first pulling
back on the sleeve. Forcing the connector out will cause damage to the cable
and/or your aircraft instrument panel.
Figure 11
Attaching and removing the
cable
Slide sleeve
to release
Align keyway
Mounting the connector
Mount the connector into a cutout, as shown in Figure 12 below.
Connect the eight wires as follows:
Two for the microphone
Two for audio
•One for power
One for ground
Two for audio shields
Audio and microphone wires should be connected to the back of the
existing microphone and headphone jacks, leaving existing jacks
intact for use with conventional headsets. This is usually the fastest
installation method (see Figures 1 – 4 for reference). Audio shields
should be connected to ground at the existing jack.
(Caution: Use of two headsets wired in parallel is not advised. This
may result in reduced performance.)
Figure 12
Harness connector and
schematic
12.5mm
.49"
.55"
14.0mm
Pin 6
Pin 1
Backnut
Front Nut
M14 X 1
Hex Nut
RED
1 V+IN
BLK
2 GND
WHT
3 COMM L
BLU
4 COMM R
WHT
5 MIC HI
WH/BLU
6 MIC LO
BLK/WH
BLK/WH
Panel Hole
Required
Receptacle -
Pinout
(Front View)
Receptacle -
Backnut
(Side View)
Aircraft
Interface
Schematic
00_AM270261-01_HeadsetXII.book Page 15 Tuesday, August 11, 2009 2:27 PM
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bose Aviation Headset X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bose Aviation Headset X in the language / languages: English as an attachment in your email.

The manual is 2.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bose Aviation Headset X

Bose Aviation Headset X User Manual - English - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info