630240
33
Zoom out
Zoom in
Previous page
1/44
Next page
Faults and what to do about them en
33
Compartment M is not
rinsed out completely.
Remove the insert. Clean the detergent drawer and reinsert it.
Odour formation in the
washer dryer.
Run the Drum Clean Û 90°C programme without laundry and deter-
gent.
Use appropriate detergent for daily washing.
keep the door and detergent dispenser open after using.
Status display Åis on.
Foam may come out of
the detergent drawer.
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
dispenser II. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
Use commercially available low foam detergent and care products which
are suitable for washer dryers.
Excessive noise, vibra-
tions and “wandering”
during the spin cycle.
Appliance aligned? Align the appliance.~ Page 42
Appliance feet fixed? Secure appliance feet. ~ Page 42
Transportation bolts are removed? Removing the transportation
bolts.~ Page 38
Display panel/indicator
lights do not function
while the appliance is run-
ning.
Power failure?
Fuse tripped? Switch on/replace fuse.
If the fault occurs repeatedly, call customer service. ~ Page 35
The programme duration
changes during the wash
cycle.
Not a fault – unbalanced load detection system adjusts imbalance.
Not a fault – foam detection function active. Additional rinse cycle.
Detergent residue on the
laundry.
Occasionally phosphate-free detergents contain water-insoluble residue.
Select Rinse O or brush items when the laundry is dry.
Spin noise during the dry-
ing phase.
This is an innovative process known as thermal spinning used to reduce
energy consumption during the drying phase.
Fluff found on the washed
laundry.
Run the Drum Clean Û (cold) programme without laundry and detergent to
remove fluff which have accumulated inside the drum during the previous dry-
ing cycle.
Water inlet noise during
the drying phase.
The washer dryer uses water condensation technology, water is constantly
needed to dry the laundry. Therefore the tap must be on all the time, till the end
of drying phase.
Drying duration extended. Run the Drum Clean Û (cold) programme to remove fluff which has col-
lected in the washer drum during the drying phase.
Drying programme does
not start.
Drying programme not selected? Overview of programmes ~ Page 20
Door not closed properly?
Faults Cause/Remedy
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch WVG30441 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch WVG30441 in the language / languages: English as an attachment in your email.

The manual is 4,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch WVG30441

Bosch WVG30441 User Manual - German - 44 pages

Bosch WVG30441 User Manual - Dutch - 44 pages

Bosch WVG30441 User Manual - French - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info