301836
10
Zoom out
Zoom in
Previous page
1/16
Next page
8
Observe any special regulations of the
responsible electricity company.
Only connect the appliance to a
properly installed socket-outlet with
earthing contact.
Ensure that the voltage information on
the appliance rating plate (on the rear
of the appliance) agrees with the mains
voltage at the installation site. The
connected load and the required fuse
or automatic m.c.b. are also given on
the rating plate.
Ensure that the plug and socket-
outlet match, that the cable cross-
section is adequate and that the
earthing system has been properly
installed.
Do not use multi-outlet sockets and
extension cables.
Only use the body of the mains plug to
pull it out of the socket-outlet. Do not
plug in with wet hands!
Only have the mains cable changed
by the after-sales service.
A vent hose with adapter is located in the
appliance drum.
Installing the vent hose
1.
Place a towel or the packing material
on the floor next to the dryer.
2.
Place the dryer on its right-hand side
(viewed from the front) on the towel or.
the packing material.
3.
Push the adapter into the hose (see
illustration). Attach the vent hose with
the adapter to the connection branch on
the bottom of the dryer.
Venting outside
Without kinking it, lead the vent hose
outside (inside diameter 10 cm,
maximum length with two bends 3
metres).
Ensure that the vent hose does not sag
when mounting the dryer on a washing
machine. It should only be run
horizontal or upwards.
Do not connect the vent hose to ventilation
systems protected by fly nets.
These can become clogged and impair
the operation of the dryer.
Do not connect the vent hose to a
chimney system.
Only connect the vent hose to ventilation
systems insulated against humidity. In
addition, obtain the approval local
Planning Office (Building Inspection
Office), the responsible chimney-sweep or
the owner of the building.
If other appliances such as gas heaters,
gas geysers, coal stoves with a chimney
connection or open fireplaces are
operated in the installation area or
neighbouring rooms, this can give rise to a
ventilation pressure causing recirculation
of exhaust gases.
Risk of poisoning
!
Have your chimney-sweep confirm
safe operation in every case.
Run the vent hose so that no direct back
pressure (e.g. wind) affects the vent
outlet.
Dryer operation without vent hose
The dryer must be placed in a large,
well-ventilated room.
Keep the room as free of dust as possible.
Minimum vent connection distance from
the wall 10 cm.
Electrical connection
Vent connection
10


Need help? Post your question in this forum.

Forumrules
1

Forum

bosch-wta-3000

Reset search

  • how do you get into the drier to set your reset button? Submitted on 28-3-2022 at 13:44

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch wta 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch wta 3000 in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info