301836
9
Zoom out
Zoom in
Previous page
1/16
Next page
7
Install the dryer in a frost-protected
room. The appliance must stand firmly
and horizontally on the floor. The two
front feet are adjustable.
Use them for alignment if necessary.
Remove the protective film from the
control panel.
Do not jam the mains cable between
the dryer and the wall.
Ensure that there is always easy
access to the earthed socket-outlet.
Stacking kit
The dryer can be placed on top of our front-
loading washing machines.
Use the accessory kit available from your
dealer for this purpose.
For safety reasons, the washer-dryer stack
must be put up by a specialist.
Minimum recess dimensions:
Width: 600 mm
Height: 860 mm
Depth: 600 mm
There are three methods of installing an air
evacuation duct:
1.
via a wall-recessed receptable into the
open air
2.
directly into the open air:
If there is a window in the installation room
then the air can be evacuated into the
open air directly through the open window
via an air evacuation hose.
The air evacuation piping should be
laid out in such a way that the dryer will
not suck back in the already expelled
warm and moist air.
The exit for the outgoing air must be
installed in such a way that no
additional counter pressure (e.g.
through direct wind entry) can arise for
the outflowing air.
3.
via a wall-recessed receptable in fire-
places or ventilation shafts
Connecting the air evacuation duct to
fireplaces with a gas or coal fire oven
attachment is not allowed.
If making a connection to a ventilation
shaft insulated against damp, notify
your chimney sweep or obtain a permit
from the local planning (construction
supervision) authorities.
If additional devices are being operated in
the installation room or neighbouring
rooms, such as gas heating, a gas flow
heater, coal fire oven with chimney
connection or open chimney, a partial
vacuum may result, which leads to the
recirculation of exhaust gases. Danger of
poisoning!
You should in any case have your chimney
sweep confirm the lack of hazards.
Connection of several dryers into a
collective ducting system:
We recommend that dryers are
NOT
connected into a collective ducting system.
This type of installation can give rise to all
sorts of problems, such as:
detrimental interaction between the dryers
damage caused by dampness
increased loss of pressure (increased
energy consumption and extended
drying period).
Installation
Installing an air evacuation duct
9


Need help? Post your question in this forum.

Forumrules
1

Forum

bosch-wta-3000

Reset search

  • how do you get into the drier to set your reset button? Submitted on 28-3-2022 at 13:44

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch wta 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch wta 3000 in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info