777045

Bosch UniversalRake 900 Manual

18
Zoom out
Zoom in
Previous page
1/303
Next page
18 | English
Noise/Vibration Information
3600H8A0.. 3600H8A1..
Noise emission values determined according to EN 50636-2-92.
Typically the A-weighted noise levels of the product are:
– Sound pressure level dB(A) 81 80
– Uncertainty K dB = 2.5 = 2.5
– Sound power level dB(A) 94 94
– Uncertainty K dB = 1.0 = 2.0
Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 50636-2-92
– Vibration emission value ahm/s24.0 2.9
– Uncertainty K m/s2= 1.6 = 1.5
Mounting and Operation
uDo not connect the product to the mains socket before
it is completely assembled.
Action Figure Page
Delivery scope A293
Assembly
Connecting the extension cable
B293
Assembling the grassbox C294
Grassbox assembly D294
Adjusting the working height E295
Switching On and Off UniversalRake
900 F295
Switching On and Off UniversalVerti-
cut 1100 G296
Maintenance, Cleaning and Storage H296
Working Advice
Raking/Verticutting
Place the product on the
edge of the lawn, as close to
the mains socket as pos-
sible. Work away from the
mains socket.
Position the cable to oppos-
ite side (already raked/ver-
ticut lawn) at the end of
each turn.
When raking/verticutting do
not overload the motor.
UniversalRake 900:
In case of overload, the speed of the motor drops and the
motor sound changes. In this case, stop, release the start/
stop lever and adjust to a higher working height. Failure to
do so could damage the machine.
UniversalVerticut 1100:
The motor is protected by a safety cut out, which is activated
when the blades become jammed, clogged or if the motor is
overloaded. When this occurs, switch the product off.
The safety cut out is only reset when the start/stop lever is
released.
Pull the mains plug, remove any blockages and wait one
minute before restarting the product so that the safety cut
out can reset itself.
uAlways wear gardening gloves when handling or work-
ing near the sharp tines/blades.
Note: When waiting for a reset of the safety cut out and actu-
ating the start/stop lever too early with the product plugged
into the socket outlet, the reset time of the safety cut out will
increase.
If the product cuts out again, increase the working height or
postpone use until conditions improve. Please refer to the
Trouble Shooting Chart" and "Raking/Verticutting Tips".
Raking/Verticutting Tips
Optimum conditions for raking/verticutting are when the
grass is short and slightly moist. Raking or verticutting the
lawn when the soil is very soft or hard can damage it and
cause the product to collect poorly.
– Kill moss with a commercially-available moss killer before
raking/verticutting.
– Start the product at the highest working height and lower
it as required.
– Rake/Verticut the lawn in the one direction, then proceed
at right angles a week later until the whole lawn has been
completed.
– Depending on the condition of the lawn, raking/verticut-
ting moss and dead plant parts can lead to ragged and
bare patches.
F 016 L94 116 | (17.02.2021) Bosch Power Tools
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch UniversalRake 900 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch UniversalRake 900 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian as an attachment in your email.

The manual is 5.58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info