697430
17
Zoom out
Zoom in
Previous page
1/48
Next page
Installation
17
Uni Condens 8000 F – 6720867056 (2016/10)
6.2 Fitting sound insulation strips
CAUTION:
Injury from crushing.
When lowering, do not reach under the boiler.
When lowering, make sure that nobody is in the danger zone.
Consider additional sound insulation measures before installing the
boiler.
To reduce the noise, place the sound insulation strips provided below the
base frame, flush with the front and back of the boiler.
Position the boiler at its installation site.
Place sound insulation strips lengthways below the boiler frame at all
four corners.
Carefully set the boiler down.
Fig. 10 Positioning the sound insulation strips
[1] Sound insulation strips
6.3 Levelling the boiler
Use metal shims to level the boiler.
To prevent air collecting in the boiler, level the boiler horizontally.
Open the burner door ( chapter 6.9.1, page 20).
Place a spirit level on the combustion chamber floor.
Level the boiler horizontally using the spirit level in the combustion
chamber.
Fig. 11 Levelling the boiler
[1] Spirit level
6.4 Flue gas and water connections for heating system
6.4.1 General requirements of the flue system
DANGER:
Danger to life through poisoning!
Insufficient ventilation can lead to dangerous flue gas leaks!
Never close off or reduce the size of the supply and extract air
apertures.
Never operate the boiler unless faults are rectified immediately.
Inform the operator in writing of any faults and their associated risks.
Implementing the following recommendations concerning the
installation of flue systems should guarantee trouble-free operation of
the combustion system. Failure to observe these requirements can result
in substantial operating problems during combustion and may even
result in explosions.
These problems frequently include acoustic disturbances, compromised
combustion stability or excessive vibrations on assemblies or their
components.
Low NOx combustion systems are to be viewed as being more sensitive
to operating faults on account of their combustion control. Therefore,
engineer and implement the flue system with particular care.
The flue system consists of a connection piece between the heat source
and the vertical flue system itself (chimney).
Due to utilization of the flue gas condensate in the heat source, the flue
system must be adapted to the flue gas condensate conditions.
0010014759-001
1
1
1
0010014745-001
1
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Uni Condens 8000 F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Uni Condens 8000 F in the language / languages: English as an attachment in your email.

The manual is 10,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch Uni Condens 8000 F

Bosch Uni Condens 8000 F User Manual - English - 12 pages

Bosch Uni Condens 8000 F User Manual - German - 16 pages

Bosch Uni Condens 8000 F User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info