112553
16
Zoom out
Zoom in
Previous page
1/56
Next page
16
Problem Possible cause Solution
Hot air in the “ cold” This is not a fault! Residual heat. The hot air disappears after a
programme. short period of time.
The light is flashing The start/stop button has been pressed It stops after 30 seconds or
during an ironing cycle: pause function. when start/stop is pressed.
The light flashes 10 times on plugging This indicates that the
the appliance into the electricity supply appliance is ready for
with the button band already lifted. operation.
The light flashes 10 times This indicates that the
on raising the appliance to its upper appliance is ready for
position when it is already plugged in. operation.
The preheating time has finished. This indicates that the
preheating time has finished
and you have 5 minutes to
press the Start/ Stop button
before the appliance switches
itself off.
Low air pressure in The ironing dummy has not been Fit the ironing dummy
the ironing dummy fitted properly. correctly.
The air filter is dirty. Clean the air filter.
Faulty ironing dummy. Replace the ironing dummy.
Excessive air pressure The airbag is not fitted properly. Check the airbag adjustment
in the ironing dummy. cords and adjust them
correctly
No air pressure in the The ironing dummy arms are twisted. Set the arms in the right
arms position.
The airbag arms are not inside the Insert the airbag arms in the
ironing dummy arms. ironing dummy arms. Fig. 25.
Ironing process too long. The 10 A version was used. Switch over to the 16 A
version if possible.
The ends of the The end of the cord has splipped into Press the button band adjuster
adjustment cords used to the gap on the button band. in and pull on the cord.
regulate size have
become hooked up on
the appliance.
The fuse triggers when The wrong connection current has Select the right connection
the appliance is been selected. current. See “Changing the
connected. connection current”.
You hear a noise on This is because the internal tube is This is not a fault and does
raising or lowering the sliding not affect correct operation
appliance. of the appliance.
Before calling the Technical Service
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch THB 1500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch THB 1500 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 2,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info