Manual Bosch THB 1500 (page 14 of 56) (English, German, Dutch)

112553

Zoom out

Zoom in

1/56

Cleaning and maintenance

❏ There are two guides on the head: front and

back.

❏ First fit the rear cord and then the front cord

into the guides on the collar and secure.

Fig. 23.

❏ The ironing dummy is joined to each airbag

via an interior cord.

❏ Once the inner airbags have been fitted,

turn the sleeves of the ironing dummy

inside out. Fig. 24.

❏ Then close the snap fasteners joining the

two parts and turn the sleeve (currently

inside out) outside out again. The arms of

the airbags are now inside the ironing

dummy arms. Fig. 25.

❏ Fit the lower adjustment cord on the ironing

dummy into the guide. Make sure that it is

secured properly. Fig. 26.

❏ On the front, the adjustment cord has to be

fitted under the 2 supports on the appliance

on the rear of the button band. Fig. 27.

❏ Tighten the fixture fitting for this cord.

❏ The fixture fitting has to be positioned into

the central rear groove, Fig. 26. Then pull

the adjustment cord again.

❏ Check that all of the adjustment cords are

secured properly.

❏ Close the button band. It clicks into position.

Check that the ironing dummy works properly:

❏ Start the “ cold” programme. The

programme can be stopped at any time by

pressing the “start/stop” button.

❏ Check that the ironing dummy is fitted

properly.

❏ Tighten any slack cords if necessary.

❏ Correct any problems.

❏ Fit the head section into the front guide.

Click the front hook into the hole on the top

part of the head.

❏ Press the head section until it clicks into

position. Fig. 28.

❏ Position each of the cuff adjusters and close

the relevant snap fasteners.

Be particularly careful when fitting the

ironing dummy and follow all the

instructions given.

The ironing dummy should only be fitted

when dry.

First fit the airbags:

❏ Each of the airbags (symmetrical) is joined

with a strip. This strip is fitted on the front

between the button band and the support

tubes. The airbag with an extra section with

2 snap fasteners in the middle must be

fitted on the left-hand side of the appliance

(looking head on).

❏ There are three snap fasteners on each

side of the shoulder area which are fitted to

the relevant airbag.

❏ Fit the adjustment cords onto the round

guides around the air-output grille and

secure the cord fixture. Fig. 21.

❏ Position the cross formation on the airbags

and close the snap fasteners on the front at

the bottom. Fig. 22.

The extra section on the bottom left-hand

side must be wrapped around the left-hand

tube, protecting the hole on the tube in this

area.

❏ Check that the adjustment cords are

secured properly.

❏ Check that the airbags are positioned

properly.

❏ Start the “ cold” programme. The

programme can be stopped at any time by

pressing the “start/stop” button.

❏ Check that the airbags are positioned

properly.

❏ Tighten any slack cords.

❏ Correct any problems.

❏ Fit the ironing dummy onto the upper part of

the appliance with the button band still

unlocked and the knob in its vertical

position.

❏ Fit the ironing dummy from back to front.

There are 4 holes on the front of the upper

part of the ironing dummy. The front

adjustment cords are on this section.

❏ When the dummy is fitted, set the knob to

horizontal.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bosch THB 1500 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 2,25 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bosch THB 1500 Manual

Product: