120602
17
Zoom out
Zoom in
Previous page
1/93
Next page
13
en
6 Standby button a
Button a switches on the appliance or
switches it to stand-by mode. When button
a is pressed, the appliance heats up and
buttonaasheswhiletheapplianceheats
up and is rinsed. When the buttons 4, 5, a
and h light up and one, two or three beans
(depending on the setting) appear on the
display, the appliance is ready for operation.
The appliance will not be rinsed if:
it was still warm when switched on, or
coffee was not discharged before it was
switched to “stand-by“ mode,
or
steam was discharged shortly before it
was switched off.
7 Steam generation button h
Button h generates steam for foaming or
warming.
8 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to hot water g or steam h.
To dispense steam, the steam generation
button hmustbepressedrst(see“Steam
for foaming milk“).
Settings and displays
Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4. You can check the water
hardness using the enclosed test strip or by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-15
16-23
24-30
1-13
14-27
28-42
43-54
●Determinethewaterhardnesswiththe
enclosed test strip.
e.g. = Hardness 2
●Switchthedevicetostandby.
●Holddownthesteambuttonh for at
least 3 seconds. The number of service
buttons 4, 5, a, h that light up indicate
the selected water hardness.
●Pressthesteambuttonh repeatedly
until the correct number of buttons is lit.
●Pressbuttona once. The selected
number of service buttons should light
upbriey;thisindicatesthatthedesired
water hardness setting has been saved
successfully.
Ifawaterlter(specialaccessory)isused,
the water hardness should be set to 1.
Note: If no button is pressed within 90
seconds, the appliance switches to stand-
by mode without saving the new settings.
In this case, the previous water hardness
setting is retained.
Thersttimealterisusedorafter
changingthelter,theapplianceneedsto
be cleaned.
●Fillthewatertankuptothe0.5lmark.
●Placeasuitablecontainer(approx.0.5
litres) under the nozzle 9.
●Turnthedial8 to g/h.
●Ifnowatercomesoutofnozzle9, turn
the dial back to O.
●Fillthewatertankandwaterpipes(see
section “Switching on the appliance”).
Adjusting the grinding unit
Sliding switch 16 adjusts the degree of
grinding,fromcoarsetone.
Warning
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged.
●Pressthecoffeedispensingbutton4.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch TCA5401CH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch TCA5401CH in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info