78124
21
Zoom out
Zoom in
Previous page
1/129
Next page
English | 21
Bosch Power Tools 2 609 003 396 | (5.12.08)
Gear Selection, Mechanical
f Actuate the gear selector 4 only when the
machine is at a standstill.
Two speed ranges can be preselected with the
gear selector 4.
Gear I:
Low speed range; for screwdriving or working
with large drilling diameter.
Gear II:
High speed range; for working with small drilling
diameter.
If the gear selector 4 cannot be fully engaged,
lightly rotate the drive spindle with the drill bit
by twisting the drill chuck.
Switching On and Off
To start the machine, press the On/Off switch
11 and keep it pressed.
The light 8 is lit when the On/Off switch 11 is
slightly or completely pressed in and permits to
light the work area when the lighting conditions
are bad.
To switch off the machine, release the On/Off
switch 11.
Adjusting the Speed
The speed of the switched on power tool can be
variably adjusted, depending on how far the
On/Off switch 11 is pressed.
Light pressure on the On/Off switch 11 results
in a low rotational speed. Further pressure on
the switch results in an increase in speed.
Fully automatic spindle locking (Auto-lock)
When the On/Off switch 11 is not pressed, the
drill spindle and thus the tool holder are locked.
This enables screws to be screwed in, even
when the battery is empty and allows for the
machine to be used as a screwdriver.
Run-on Brake
When the On/Off switch 11 is released, the
chuck brakes to a stop, thus preventing the run-
on of the tool.
When driving in screws, wait until the screw is
screwed in flush with the material and then re-
lease the On/Off switch 11. By doing so, the
head of the screw does not penetrate into the
material.
Battery Charge-control Indication
The battery charge-control indicator 9 consists
of three green LEDs, and indicates the charge
condition of the battery for a few seconds when
the On/Off switch 11 is pressed halfway or fully.
The 3 LEDs of the battery charge-control indica-
tor 9 and the Power Light 8 flash rapidly when
the battery temperature is not within the opert-
ing temperature range of –10 to +70°C.
Temperature Dependent Overload Protection
When using as intended for, the power tool can-
not be subject to overload. When the load is too
high or the allowable battery temperature of
70 °C is exceeded, the electronic control
switches off the power tool until the tempera-
ture is in the optimum temperature range again.
The 3 LEDs of the battery charge-control indica-
tor 9 and the “Power light” 8 flash rapidly when
the battery temperature is not within the oper-
ating temperature range of –10 to +70°C and/or
when the overload protection has actuated.
Protection Against Deep Discharging
The Li-ion battery is protected against deep dis-
charging by the “Electronic Cell Protection
(ECP)”. When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
LED Capacity
Continuous lighting 3 x green 71%
Continuous lighting 2 x green 3570%
Continuous lighting 1 x green 1134%
Slow flashing 1 x green 10%
OBJ_BUCH-900-001.book Page 21 Friday, December 5, 2008 9:09 AM
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch PSR 14,4 LI-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch PSR 14,4 LI-2 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch PSR 14,4 LI-2

Bosch PSR 14,4 LI-2 User Manual - English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish - 127 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info