697310
13
Zoom out
Zoom in
Previous page
1/108
Next page
6 720 813 621 (2014/12)MM100
Product details | 13
Anti-seize protection:
The connected pump is monitored and exercised for a
short while after 24 hours of non-activity. This
prevents the pump from seizing.
The connected mixing valve actuator is monitored and
run automatically for a short period after 24 hours of
non-activity. This prevents the mixer from seizing up.
A maximum of 6 MM100 modules are permitted in one system
irrespective of the number of other BUS nodes.
As delivered, the coding card is in position 0. The module will
only be registered in the user interface if the coding card is in a
valid position for the heating circuit or cylinder primary circuit
(usually behind the low loss header).
A system schematic with 3 heating circuits with mixing valves,
one heating circuit without mixing valve and one primary
cylinder circuit is shown in Fig. 24 on page 103. A further
example with 3 or more heating circuits and 2 primary cylinder
circuits is shown in Fig. 27 on page 106.
2.1 Important notices on usage
The module communicates via an EMS 2/EMS plus interface
with other EMS 2/EMS-plus-enabled BUS nodes, such as
Greenstar boilers.
The module must only be connected to user interfaces with
the EMS 2/EMS plus (Energy Management System) BUS
interface.
The functional scope depends on the user interface
installed. Detailed information about user interfaces can be
found in the catalogue and technical guides and on the
manufacturer's website.
The installation space must be suitable for the IP rating
stated in the module specification.
2.2 Standard delivery
Fig. 1, page 91:
[1] Module
[2] Jumper for connection to MC1 if there is no temperature
switch in the assigned heating circuit (without mixer)
[3] Bag with strain relief
[4] Installation set flow temperature sensor
[5] Installation instructions
2.3 Technical data
The design and operation of this product comply
with European Directives and the supplementary
national requirements. Its conformity is
demonstrated by the CE marking. You can ask for a copy of the
declaration of conformity for this product. For this see the
contact address on the back cover of these instructions.
WARNING: Risk of scalding!
If DHW temperatures above 60 °C are set
or thermal disinfection is switched on, a
mixing valve must be installed at the DHW
outlet or at the DHW draw off points.
NOTICE: Floor damage!
Underfloor heating systems must only be
operated with an additional temperature
limiter (MC1 connection).
Technical data
Dimensions (W×H×D) 151×184×61mm (further
dimensions Fig. 2, page 91)
Maximum conductor
cross-section
230 V terminal
•Extra-low voltage
terminal
•2.5mm
2
•1.5mm
2
Rated voltages
•BUS
Module power supply
•User interface
•Pump and mixer
15 V DC (reverse-polarity-
protected)
230 V AC, 50 Hz
15 V DC (reverse-polarity-
protected)
230 V AC, 50 Hz
Circuit breaker 230 V, 5 AT
BUS interface EMS 2/EMS plus
Power consumption on
standby
<1W
Maximum output
Per connection (PC1
Pump Connection)
Per connection
(VC1 Mixing Valve
Connection)
400 W (high-efficiency
pumps permissible;
max. 40 A/s)
•100W
Temperature sensor
capturing range
lower fault limit
•display range
upper fault limit
•< 10°C
•0-100°C
> 125 °C
Table 3
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch MM 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch MM 100 in the language / languages: German, Dutch, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 6,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch MM 100

Bosch MM 100 Installation Guide - English, Danish, French, Polish, Swedish, Turkish, Norwegian, Finnish - 116 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info