774961
7
Zoom out
Zoom in
Previous page
1/65
Next page
7
Preparation en
Cable storage compartment
X Fig. C
The appliance is equipped with a cable
storage compartment. The length of the
power cord can be adjusted as required by
pulling out or pushing it back.
After finishing work, push the power cord
into the cable storage compartment by
jerking it back in.
Preparation
Place the base unit on a flat, clean and
stable surface.
Pull the power cord out to the required
length.
W Risk of injury!
Do not insert the mains plug until
all preparations for working with the
appliance are complete.
While operating the appliance, never
reach into the bowl or filling shaft.
After switching off, the drive continues
running for a short time. Change
tools / accessories only once the drive is
at a standstill.
Important!
Do not switch the appliance on until
tools or accessories have been
completely attached.
The appliance cannot be switched on
unless the bowl has been inserted
correctly and closed with the lid. The lid
lug must be fully inserted in the slot of
the bowl handle.
Only use the rotary switch to switch the
appliance on and off.
Use of tools
W Risk of injury!
While operating the appliance, never reach
into the bowl or filling shaft with your hands.
Do not insert any objects (e.g. wooden
spoon) into the bowl or filling shaft.
Universal blade
For cutting and chopping.
W Risk of injury!
Do not touch the sharp edges of the uni-
versal blade with bare hands. When not
in use, always store the universal blade in
the blade guard. Take hold of the universal
blade by the edge of the plastic handle only.
Kneading hook (plastic)
For kneading dough (e.g. yeast
dough, cake mixture) and mixing in
ingredients which are not to be cut up
(e.g. raisins, chocolate chips).
X Fig. D
1. Attach the bowl. Observe the
marking (.) when doing so. Rotate the
bowl clockwise as far as possible.
2. Press drive shaft 1 into the tool holder
until it locks into position.
3. Place the tool holder with the drive shaft
on the drive. Place the universal blade
or kneading hook on the tool holder and
release.
Caution!
Do not add ingredients until tools have been
fitted.
4. Add ingredients.
5. Attach the lid with the pusher. Observe
the marking (.) when doing so.
6. Rotate the lid clockwise as far as
possible.
7. Insert the mains plug. Set the rotary
switch to the desired setting.
Adding more ingredients
8. To add more ingredients, set the rotary
switch to P. Remove the pusher
and add ingredients through the filling
opening.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch MC812S734G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch MC812S734G in the language / languages: English as an attachment in your email.

The manual is 4.5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info