708274
29
Zoom out
Zoom in
Previous page
1/375
Next page
English | 29
Bosch Power Tools F 016 L81 221 | (2.12.16)
Troubleshooting
Online Support
http://www.bosch-indego.com
Problem Possible Cause Corrective Action
The LED on docking
station flashes
The perimeter wire is broken, too long or too
short. Wire not connected and mower not in
the docking station
Check perimeter wire is not broken and is between 20
and 250 meters in length. Then switch off and on power
supply.
Follow instructions in Installation guide to install the
mower.
Excessive vibrations/
noise
Blade nut/bolt loose Tighten blade nut/bolt to torque of 2.5 Nm
Cutting blade damaged Replace the blade
Machine not docking
reliably
Perimeter wire not properly setup around
dock
Follow instructions in installation guide to align wire
Perimeter wire close to a source of interfer-
ence
Leave adequate distance between your perimeter wire
and source of interference (approx. 1 m)
Change perimeter wire ID in the menu
Machine fails to oper-
ate
Isolator switch not turned on Remove mower out of the dock, turn on switch and re-
place mower back in the dock (ensure dock is on LED
is solid green). Press confirm button for screen to light
up. Enter 4 digit PIN to activate your mower
Possible clogging Always turn isolator switch off first, then check under-
neath the mower and clear out as necessary (always
wear protective gloves)
Battery not fully charged Replace mower in the docking station to charge. Docking
station must be on.
Grass too long Mow garden to at least 40mm before using Indego.
Increase height of cut
Battery too hot/cold Allow mower to cool/warm or move dock to area of
shade. Mower runs when battery internal temperature is
between 5°C 45°C
Perimeter wire close to a source of interfer-
ence
Leave adequate distance between your perimeter wire
and source of interference (approx. 1 m)
Change perimeter wire ID in the menu
Machine does not
charge
Battery too hot/cold Allow mower to cool/warm or move dock to area of
shade. Mower runs when battery internal temperature is
between 5°C 45°C
Docking station not switched on Switch on power supply to docking station or contact
your Bosch service centre
OBJ_BUCH-3008-002.book Page 29 Friday, December 2, 2016 12:09 PM
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Indego 400 Connect at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Indego 400 Connect in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 54,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info